JTECH Extend Two-Way Radio

Thank you for purchasing JTECH Extend Radios.
For full detailed information, please consult the instruction manual.

Components

Product Controls / Keys

1. Charger Terminal
2. Speaker
3. Microphone
4. Channel Down Key
   Select item key in Local setting Mode
5. F, Programmable function key – Default Key Lock @long press, Flashlight@short press, Exit current status key in local setting mode
6. S/M, Programmable function key – Default Menu long press, Scan @short press
7. A, Channel Up Key – Select item key in Local pro- gramming Mode
8. LCD display – refer to the below symbols list.
9. SF2, Programmable function key Default: Channel view@short press, Monitor @long press
10. SF1, Programmable function key – default PTT
11. LED Flashlight
12. LED Indicator (Tx & Busy)
13. Power switch/ Volume Knob
14. Head set Jack /Programming Cable Jack
15. Belt clip screw hole
16. Antenna
17. Battery cover
18. Open slot for battery cover

BATTERY INSTALLATION

• Remove the battery cover by pushing down the recess part on the door. Slide the battery door off the radio.
• Install the rechargeable Lithium Ion (Li Ion) battery provided.
• Slide and snap the battery door into place

CHARGING THE BATTERY / RADIO

• Place the multi unit charger on a flat surface.
• Insert the plug of the power cord into the jack of the charger.
• Plug the cord into an AC outlet.
• Turn the radio off.
• Insert the radio (with battery installed) into the charging slots. LED will light up. The LED is solid red when battery is charging and solid green when charging is complete.
• Charge the radios at least 4-6 hours prior to use.

BASIC RADIO OPERATION

• To talk, press and hold the “Push to Talk” button and speak into the microphone. Hold the radio 2-3 inches away from your mouth.
• To listen, release “Push to Talk”.
• NOTE *When using an earpiece, you must use the Push to Talk button located on the earpiece wire, not on the radio.

SCAN FOR ACTIVE CHANNEL

• To scan for active channel, press the S/M key. The scan icon will display, and the radio will begin to scan the channels.
• When the radio detects activity, it stops on that channel and displays the channel number.
• To talk to the person transmitting without switching channels, press the Push-to-talk button before scan resumes.
• To stop scanning, press the “S/M” key.

For help contact wecare@jtech.com or call 800.321.6221

Documents / Resources

	JTECH Extend Two-Way Radio [pdf] User Guide Extend Two-Way Radio, Extend, Two-Way Radio, Radio
	JTECH Extend Two Way Radio [pdf] Owner's Manual Extend Two Way Radio, Extend, Two Way Radio, Way Radio, Radio

References

• User Manual