JSOUL JS05 Active Noise Cancelling Bluetooth Earbuds
OVERVIEW
WEARING
- M eartips on the earbuds
- L and S eartips for more sizes
- Adjust earbuds angle for better fittings.
BLUETOOTH
- Remove insulation films on earbuds. Put earbuds into the charging case. Close the case (for first pairing).
- Pairing Mode: Take out earbuds, one earbud LED flash blue &white, the other LED flash solid white.
- Enter your bluetooth device settings and select: JSoul Mate Air and LED will turn off after pairing sucessfully.
- If Bluetooth pairing failed, refer to RESET section then try the pairing process above again .
CHARGING
BLUETOOTH MULTIPOINT
- Once FIRST device is connected, turn off Bluetooth in device settings. JSoul Mate Air will auto enter bluetooth pairing.
- Enter your SECOND device bluetooth settings and connect to JSoul Mate Air.
- Enter FIRST device settings. Turn on bluetooth and reconnect to JSoul Mate Air.
FACTORY RESET
Put earbuds into the case and close it then long-press press RESET button for 3S+, earbuds LED will blink blue 4 times when reset successfully.
TOUCH FUCTION
INSIDE BOX
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
MODIFICATION: Any changes or modifications not expressly approved by the grantee of this device could void the user’ s authority to operate the device.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure rules as this equipment has very low levels of RF energy.
FCC ID: 2 BKCV-JS05
Documents / Resources
 |
JSOUL JS05 Active Noise Cancelling Bluetooth Earbuds [pdf] User Guide JS05, JS05 Active Noise Cancelling Bluetooth Earbuds, Active Noise Cancelling Bluetooth Earbuds, Noise Cancelling Bluetooth Earbuds, Cancelling Bluetooth Earbuds, Bluetooth Earbuds, Earbuds |