ITC 69640H-X-X Modular Nav Light Instruction Manual
PARTS/TOOLS NEEDED
- Navigation Light
- Screws Bezel Mount Only (not provided)
- Power Drill (not provided)
- Marine Wire Connectors (not provided)
- Application Specific Sealant (not provided)
INSTALLATION CONSIDERATIONS
- Disconnect power before installing, adding or changing any component.
- To avoid a hazard to children, account for all parts and destroy all packing materials.
- It is recommended that fuse protection be added to the positive (+) input.
- All electrical connections should be made inside a watertight junction box.
- *Visit https://www.uscgboating.org/regulations/navigation-rules.php for full navigation regulations.
Backnut No Bezel Version
- Drill a 7/8” hole in your mounting surface then feed the wires through the pre-drilled hole.
- Wire the light using the the wiring diagram. Use application specific sealant around the light to prevent any ingress of water. Screw on the back nut to the light until tight.
Screw Mount Bezel Version
- Drill a 7/8” hole in your mounting surface and predril screw holes. Feed the wires through the pre-drilled 7/8” hole
- Wire the light using the the wiring diagram. Use application specific sealant around the light to prevent any ingress of water. Screw on the bezel.
Wiring Diagram
Wire the light based on the wiring diagram. Use silicone sealant around the light to prevent any ingress of water.
For warranty information please visit www.itc-us.com/warranty-return
3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
Documents / Resources
 |
ITC 69640H-X-X Modular Nav Light [pdf] Instruction Manual 69640H-X-X Modular Nav Light, 69640H-X-X, Modular Nav Light, Nav Light, Light |