ITC 2300X-KKKK-NM-01 Smart System Plus
Product Specifications
- Product Name: VersiControl Smart System Plus – NMEA
- Part Number: 2300X-KKKK-NM-01
- Mating Connectors: NMEA 2000 Female
- Power Wires: DTP06-2S
- RGB Wires: DT04-4P
- RGBW Wires: DT04-6P
- Addressable Wires: DT04-3P
- Maximum Replacement Fuse Size: 20 amps
Wiring Instructions
Follow the specific wiring diagram based on the model you have:
-
- 23002-RGB-NM-01 – Two Standard RGB Zones
- 23002-RGBW-NM-01 – Two Standard RGBW Zones
- 23004-RGB-NM-01 – Four Standard RGB Zones
Note: Always ensure that the maximum replacement fuse size does not exceed 20 amps.
Safety Instructions
- Disconnect power before installing, adding or changing any component.
- To avoid a hazard to children, account for all parts and destroy all packing materials.
- Do not install any luminaire assembly closer than 6” from any combustible materials.
- Positive (+) outputs require a fuse if the attached wire leads are not rated to handle the max current.
- This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference
- This device must accept any interferences received, including interference that may cause undesired operation
Mating Connectors
| NMEA | Power Wires | RGB Wires | RGBW Wires | Addressable Wires |
| NMEA 2000 Female | DTP06-2S | DT04-4P | DT04-6P | DT04-3P |
WIRING DIAGRAMS: Follow the wiring diagram below to wire the module to your system. Note: Maximum replacement fuse size is 20 amps.
- 23002-RGB-NM-01 – Two Standard RGB Zones
- 23002-RGBW-NM-01 – Two Standard RGBW Zones
- 23004-RGB-NM-01 – Four Standard RGB Zones
- 23004-RGBW-NM-01 – Four Standard RGBW Zones
- 23004-RGB-NM-01 – Four Standard RGB Zones
- 23004-RGBW-NM-01 – Four Standard RGBW Zones
- 23022-RGB-NM-01 – Two Standard RGB/Two Addressable
- 23022-RGBW-NM-01 – Two Standard RGBW/Two Addressable
- 23040-RGBW-NM-01 – Four Addressable Zones
Contact
- address: 3030 Corporate Grove Dr. Hudsonville, MI 49426
- Phone: 616.396.1355
- itc-us.com
FAQ
- Q: What should I do if I encounter interference during the operation?
- A: Ensure that the device is accepting any interferences received and follow the troubleshooting steps in the user manual.
- Q: Can I use a fuse larger than 20 amps for replacement?
- A: No, it is recommended to use a maximum replacement fuse size of 20 amps to prevent damage to the device.
Documents / Resources
 |
ITC 2300X-KKKK-NM-01 Smart System Plus [pdf] Installation Guide 2300X-KKKK-NM-01, 23002-RGB-NM-01, 23002-RGBW-NM-01, 23004-RGB-NM-01, 23004-RGBW-NM-01, 2300X-KKKK-NM-01 Smart System Plus, 2300X-KKKK-NM-01, Smart System Plus, System Plus, Plus |
