55001384 Autonomy Controller Module
“
Specifiche
Produttore: Carnegie Robotics
Numero modello: 55001384
Istruzioni per l'integrazione: KDB 996369 D03 OEM
Manuale v01
Istruzioni per l'uso del prodotto
1. Conformità alle norme FCC
The module integrator must assess worst-case operating
conditions and test the host product for compliance to FCC Part
15.247 and Part 15.407.
2. Condizioni di utilizzo operativo
The module is standalone. Consult with the module manufacturer
for installation methods if the end product involves multiple
simultaneous transmissions or different operational conditions.
3. RF Exposure Guidelines
Install and operate the equipment at a minimum distance of 20cm
from the body to comply with FCC’s and ISED’s RF Exposure
linee guida.
4. Antenne
This radio transmitter is FCC approved to operate with specific
antenna types and maximum permissible gain. Use only approved
antennas listed in the manual.
5. Labeling and Compliance
The final end product must be labeled with FCC ID:
2AMDR-55001384 and IC: 24410-55001384 in a visible area.
6. Additional Testing Requirements
Host manufacturers are advised to confirm compliance with FCC
and ISED requirements when the module is installed in the host
sistema.
7. Attenzione FCC
Eventuali cambiamenti o modifiche non approvate potrebbero invalidare la validità dell'utente
autorizzazione a utilizzare l'attrezzatura.
Domande frequenti
Q: What are the recommended distances for RF exposure
conformità?
A: The equipment should be installed and operated at a minimum
distance of 20cm from the body to comply with FCC’s and ISED’s RF
Linee guida sull'esposizione.
D: Posso utilizzare antenne non elencate nel manuale?
A: I tipi di antenna non inclusi nell'elenco approvato sono rigorosamente
prohibited for use with this device to maintain compliance.
“`
Carnegie Robotics 55001384 Integration Instructions
Descrizione:
Qualcomm® Robotics RB5 Core Kit consisting of Thundercomm TurboX C865 System on Module with customization around 12GB Ram and external antennas enabled for system integration.
See Qualcomm or Thundercomm hardware manuals for specifications to each product.
Integration instructions for host product manufacturers according to KDB 996369 D03 OEM Manual v01 (ISED recognized)
2.2
Elenco delle norme FCC applicabili
È stato esaminato il CFR 47 FCC PARTE 15 CAPITOLO C&E. È applicabile al modulare.
Specifically, an assessment of the worst case operating conditions has to be performed by the module integrator and tested on the host product for compliance to FCC part 15.247 and part 15.407.
2.3
Condizioni specifiche di utilizzo operativo
This module is a stand-alone module. If the end product will involve the Multiple simultaneously
transmitting condition or different operational conditions for a stand-alone modular transmitter in a host,
the host manufacturer has to consult with the module manufacturer for the installation method in the end
sistema.
2.4
Limited module procedures. – Not applicable
2.5
Trace antenna designs. – Not applicable
2.6
Considerazioni sull'esposizione alle radiofrequenze
To maintain compliance with FCC’s and ISED’s RF Exposure guidelines, this equipment should be
installed and operated at a minimum distance of 20cm from your body.
2.7
Antenne
This radio transmitter FCC ID: 2AMDR-55001384 / IC: 24410-55001384
has been approved by the Federal Communications Commission to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with this device.
Carnegie Robotics LLC, 4501 Hatfield St. Pittsburgh, PA 15201, USA, Phone Numero di telefono: 412-200-5539
Identificazione interna
Antenna 0**
Antenna Description Wi-Fi Antenna
Tipo di antenna
External Antenna 2X MIMO WIFI
Guadagno massimo dell'antenna
2.4G Wi-Fi: 1.2 dBi, 5G Wi-Fi: 2.0dBi
Antenna 1
Antenna Wi-Fi
External Antenna 2X MIMO WIFI
2.4G Wi-Fi: 1.2 dBi, 5G Wi-Fi: 2.0dBi
**Bluetooth has been disabled on device and has not been tested
Antennas Tested: Abracon Part Number AECW0401W2-0600F_DS Taoglas MA210.K.CG.001
2.8
Label and compliance information.
Il prodotto finale deve essere etichettato in un'area visibile con quanto segue:
Contains FCC ID: 2AMDR-55001384, IC: 24410-55001384
2.9
Informazioni sulle modalità di prova e sui requisiti di prova aggiuntivi
Host manufacturers are strongly recommended to confirm compliance with FCC and ISED requirements
for the transmitter when the module is installed in the host.
2.10
Test aggiuntivi, parte 15, capitolo B e disclaimer ICES-003
The host manufacturer is responsible for compliance of the host system with module installed with all other
applicable requirements for the system such as FCC Part 15 B and ICES-003.
Attenzione FCC:
Carnegie Robotics LLC, 4501 Hatfield St. Pittsburgh, PA 15201, USA, Phone Numero di telefono: 412-200-5539
Eventuali modifiche o alterazioni non espressamente approvate dalla parte responsabile della conformità potrebbero invalidare il diritto dell'utente a utilizzare l'apparecchiatura.
FCC and ISED Statements This device complies with Part 15 of the FCC Rules and with ICES-003 of the ISED rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR Innovation, Sciences et Développement économique (d’ISDE) Canada applicables aux appareils radio. L’exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est suscettibile d'en compromettre le fonctionnement.
IMPORTANT NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules and ICES-003 of the ISED Canada rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
–Riorientare o riposizionare l’antenna ricevente.
–Aumentare la separazione tra l’apparecchiatura e il ricevitore.
Carnegie Robotics LLC, 4501 Hatfield St. Pittsburgh, PA 15201, USA, Phone Numero di telefono: 412-200-5539
–Collegare l'apparecchiatura a una presa su un circuito diverso da quello a cui è collegato il ricevitore. –Consultare il rivenditore o un tecnico radio/TV esperto per assistenza.
Statements regarding human exposure With respect to radiofrequency radiation exposure Information, it is declared that this equipment complies with FCC and ISED radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated at a minimum distance of 20 cm between the radiator and your body. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
Déclarations concernant l’exposition humaine Respectant les informations relatives à l’exposition aux radiations de fréquences radio, on déclare que cet équipement respecte les limites d’exposition aux radiations de l’ISDE aux conditions prévues pour un environnement non contrôlé. Cet équipement doit être installé et fonctionner à une distance minimale de 20 cm entre l’appareil irradiant et votre corps. Cet émetteur ne doit pas être installé ou utilisé en conjonction avec d’autres antennes ou d’autres émetteurs.
Carnegie Robotics LLC, 4501 Hatfield St. Pittsburgh, PA 15201, USA, Phone Numero di telefono: 412-200-5539
Documenti / Risorse
 |
Carnegie Robotics 55001384 Autonomy Controller Module [pdf] Manuale di istruzioni 55001384, 2AMDR-55001384, 2AMDR55001384, 55001384 Autonomy Controller Module, 55001384, Autonomy Controller Module, Controller Module, Module |