Leiðbeiningar um uppsetningu á gluggahandfangi fyrir Prado HW001
Use an outdoor connection box for the wire connections.
Gakktu úr skugga um að slökkt sé á rafmagninu.
Make the connection inside the box using a waterproof connector (min IP67).
Combine with prado LED-driver , respect polarity:
- for constant current: serial connection
- for 24V driver: parallel connection
The installer is responsible for using the correct wire section and must consider the maximum cable length to ensure safe and eicient system operation. Incorrect wire choice can lead to overheating, voltage-fall og skemmdir á búnaði.
Important Note for the Installer:
Ensure the external electrical connection for this fixture is waterproof. It is the installer’s responsibility to use materials and techniques that meet IP standards and prevent water ingress. Failure to waterproof the connection may lead to xture damage, electric shock, or short circuits. Any risks or damages from improper waterproofing are the installer’s responsibility.
We strongly recommend using appropriate water proofing materials for the installation environment.
Settu upp búnaðinn.
Snúðu festingunni eins og þú vilt og kveiktu aftur á henni.
To prevent overheating, do not light the fixture in the sunlight.
Thank you for choosing prado
The light source or electronics in this xture shall only be replaced by the manufacturer. Warranty will not apply in case of wrongful use or if unskilled personnel attempts to repair the product.
Lestu meira um þessa handbók og halaðu niður PDF:
Skjöl / auðlindir
 |
Prado HW001 Gluggahandfang [pdfUppsetningarleiðbeiningar HW001, HW001 Gluggahandfang, HW001, Gluggahandfang, Handfang |