IRONBISON IB-TRS-032 Rocker Step Running Boards
Features
- 60-120 min
- Cutting Not Required
- Drilling Not Required
Torque & Tools
| Fastener Size | Tightening Torque (ft-lbs) | Wrench Required | Allen Wrench Required | ||
| 6mm | 7-8.5 |  |
10mm |  |
4mm |
| 8mm | 18-20 | 13mm | 5mm | ||
| 10mm | 35-40 | 16mm | 6mm | ||
| 12mm | 60-70 | 18mm | 8mm | ||
BEFORE INSTALLATION
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT DEPEND ON THE PARTS LIST. READ INSTRUCTIONS CAREFULLY. BUMPER IS HEAVY, ASSISTANCE IS HIGHLY RECOMMENDED TO AVOID POSSIBLE INJURY OR DAMAGE TO THE VEHICLE.
Part List
- 8mm x 30mm Hex Bolt x16
- 8mm Flat Washer x16
- 8mm Lock Washer x16
- 8mm x 25mm Combo Bolt x16
PLEASE NOTE THAT THE FOLLOWING PICTURES ARE BASED ON THE PASSENGER SIDE INSTALLATION.
Installation Step
STEP 1
Starting on the Passenger/Right front of the vehicle, remove the plastic plugs, (or hex bolts), covering the threaded holes in the body panel, (Fig 1).
STEP 2
Select the Passenger/Right Front Mounting Bracket. Attach the Bracket to the vehicle with (2) 8mm Hex Bolts, (2) 8mm Lock Washers and (2) 8mm Flat Washers, (Fig 2). Do not tighten hardware at this time.
STEP 3
Next, move to the 2nd mounting location, (Fig 3).
Select the Passenger/Right side Center/Rear Mounting Bracket, (Fig 4). IMPORTANT: The Center and Rear Brackets are the same. Repeat Step 2 to install the center Mounting Bracket, (Fig 4).
STEP 4
Repeat Steps 3 to attach the (2) Passenger/Right Side Center & Rear Bracket to the (2) remaining Mounting Location.
STEP 5
Select the Passenger/Right Rocker Step.
NOTE: The Passenger/Right will have a “32-R” on the front. Carefully place Rocker Step on the brackets. IMPORTANT: Do not slide the Rocker Step front to back or damage to the finish may result. Attach Rocker Step to the Mounting Brackets with (6) 8mm Combo Bolts, (Fig 5). Do not tighten hardware.
STEP 6
Level and adjust the Rocker Step and fully tighten all hardware
STEP 7
Repeat Steps 1—6 to attach the Driver/Left Rocker Step.
STEP 8
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
Attention
To protect your investment, do not use any type of polish or wax that may contain abrasives that could damage the finish.
Mild soap may be used also to clean the Running Boards.
Documents / Resources
 |
IRONBISON IB-TRS-032 Rocker Step Running Boards [pdf] Installation Guide IB-TRS-032 Rocker Step Running Boards, IB-TRS-032, Rocker Step Running Boards, Step Running Boards, Running Boards |
