Install Essentials DUB1 Digital Tilt Motion Sensor
Product Information
Description
The DUBl Digital Tilt Sensor is designed to detect tilting or movement of a vehicle and trigger an alarm system.
Specifications
- Mounting: Rigid and flat surface inside the vehicle
- Sensitivity Levels: Level 1 (default) at 1 degree tilt, Level 2 at 3 degrees tilt
- Arming Delay: Default 110 seconds, optional 2-minute delay
Product Usage Instructions
Mounting the Sensor
Select a suitable rigid and flat location inside the vehicle. Avoid placing near heating/air conditioning vents. Ideal locations include under dash braces, top of transmission hump, or under a seat. Wire the sensor following the provided diagram.
Testing the Sensor:
Arm the system and slowly jack up the vehicle from all four sides. The sensor should trigger approximately 2 seconds after tilting the vehicle.
Adjusting Sensitivity Level:
There are two sensitivity levels. To change the sensitivity level:
- Max Sensitivity (Level 1): Do not cut the BLACK loop.
- Min Sensitivity (Level 2): Cut the BLACK loop.
Adjusting Arming Delay:
To change the arming delay:
- Default 110-second delay: Do not cut the WHITE loop.
- 2-minute delay: Cut the WHITE loop.
Product Description
- The DUBl is a digital tilt sensor, activated by the armed output of your vehicle’s alarm system. Even if the vehicle is parked on the steepest hill the DU Bl will self-adjust and accurately respond to tilt, motion, or other tampering. The DUBl continually self-ad ·usts so there i never any need for sensitivity adjustments
MOUNTING THE SENSOR
- Select a suitable rigid and flat mounting location inside the vehicle that is horizontal (it does not have to be perfectly level). Avoid placing directly on or near heating/air conditioning vents. Ideal locations include flat under-dash braces, on top of the transmission hump (under the carpet) or under a seat. Wire the sensor as shown in the diagram below
- Test the sensor by arming the system and then slowly jack up the vehicle. Do this from all four side of the vehicle, the sensor should trigger about 2 seconds after the vehicle has been tilted.
- There are two levels for sensitivity. Levell (default) is the max sensitivity setting and will be activated at l degree of tilt. Level 2 is the min sensitivity setting and will be activated at 3 degrees of tilt. To change the sensitivity level, see the sensitivity setting below
SENSITIVITY SETTING – BLACK LOOP
- Max Sensitivity – Default level, do not cut the BLACK loop.
- Min Sensitivity – Cut the BLACK loop
ARMING DELAY-WHITE LOOP
- 10-second delay– Default level, do not cut the WHITE loop.
- 2-minute delay– Cut the WHITE loop.
more info
- Orlando, FL 32824
- Main Toll Free: 800-876-0800
- Authorized Dealer Support: www.directechs.com
FAQs
Q: How do I know if the sensor is triggered?
A: The sensor will trigger the alarm system when it detects tilting or movement beyond the set sensitivity level.
Q: Can the sensitivity level be adjusted while the system is armed?
A: No, it is recommended to adjust the sensitivity level when the system is disarmed to avoid false alarms.
Documents / Resources
 |
Install Essentials DUB1 Digital Tilt Motion Sensor [pdf] Owner's Manual DUB1, DUB1 Digital Tilt Motion Sensor, DUB1, Digital Tilt Motion Sensor, Tilt Motion Sensor, Motion Sensor, Sensor |