infinity Reference 1200D Subwoofer
INTRODUCTION
THANK YOU FOR CHOOSING THIS INFINITY
PRODUCT
This product has been designed to deliver great bass performance from a compact, easily installed enclosure. To get the best performance from your enclosure, we strongly recommend that you entrust installation to a qualified professional. Although these instructions explain how to install your enclosure in a general sense, they do not show specific installation methods that may be required for your particular vehicle. If you do not have the necessary tools or experience, do not attempt the installation yourself. Instead, please ask your authorized INFINITY car audio dealer about professional installation. To help us serve you better if your enclosure ever requires warranty service, please retain your original sales receipt and serial number.
INSTALLATION WARNINGS AND TIPS
INSTALLATION TIPS
- Always wear protective eyewear when using tools.
- Turn off all audio components and other electrical devices before you start. Disconnect the negative (–) lead from your vehicle’s battery.
- Check clearances on both sides of a planned mounting surface. Be sure that screws or wires will not puncture brake lines, fuel lines or wiring harnesses, and that wire routing will not interfere with the safe operation of the vehicle.
- When making electrical connections, make sure they are secure and properly insulated.
- Before drilling or cutting holes, use a utility knife to remove unwanted fabric or vinyl, to keep material from snagging in a drill bit or saw.
- Do not mount speakers where they will get wet.
MOUNTING LOCATION
CHOOSING A MOUNTING LOCATION FOR THE ENCLOSURE
Choose a mounting location that doesn’t interfere with cargo, the fold-down rear seat or the trunk lid. The best location is usually a corner of the trunk or cargo area. Securely mount the enclosure to the mounting surface.
WARNING: Playing loud music in an automobile can permanently damage your hearing as well as hinder your ability to hear traffic. Listening at low levels while driving is recommended. HARMAN International accepts no liability for hearing loss, bodily injury or property damage resulting from use or misuse of this product.
SPEAKER CONNECTIONS
Connect the + and – terminals on the enclosure to the amplifier’s outputs, observing proper polarity. Use at least 5mm2 (10 AWG) speaker wire for the connections to the enclosure.
SPECIFICATIONS
REFERENCE 1200D
- Subwoofer:
2x 12″ (300mm) Polypropylene Driver - Power Handling:
800W RMS, 1600W peak - Sensitivity (1W/1m):
89dB - Frequency Response (-6dB):
30Hz – 400Hz - Nominal Impedance:
2 ohms - Voice Coil Diameter:
2″ (50mm) - Enclosure dimensions:
357.8mmD1 x 434.2mmD2 x 815mmW x 383mmH
14-1/16″D1 x 17-1/8″D2 x 32-1/16″W x 15-1/16″H - Enclosure materials:
13/16″ (21mm) MDF with black carpet covering
GENERAL CARE
The loudspeaker may be cleaned with a damp cloth. Do not use any cleaners or solvents.
A valid serial number is required for warranty coverage. This product is designed for mobile applications and is not intended to connect to the mains.
CONTACT
Harman International Industries, Incorporated 8500 Balboa Blvd, Northridge, CA 91329, UNITED STATES. www.infinityspeakers.com
© 2023 HARMAN International Industries, Incorporated. All rights reserved. Infinity is a trademark of HARMAN International Industries, Incorporated, registered in the United States and/or other countries. Features, specifications and appearance are subject to change without notice.
CA_INFINITY_Reference 1200D subwoofer_OM_Global_CR_V7_online
Documents / Resources
 |
infinity Reference 1200D Subwoofer [pdf] Owner's Manual Reference 1200D, Reference 1200D Subwoofer, Subwoofer |
