Modul nnyefe laser
Ụdị: KY-008
Akwụkwọ ntuziaka onye ọrụ
Ihe nfefe Laser Pinout
Nke a modul nwere 3 pin:
VCC: modul ọkọnọ ike - 5V
GND: Ala
S: PIN mgbaàmà (iji rụọ ọrụ na gbanyụọ laser)
Ị nwere ike ịhụ pinout nke modul a na foto dị n'okpuru:
IKE 
GND 
Signal 
Ihe achọrọ
Mara:
Ebe ọ bụ na ihe achọrọ ugbu a bụ 40 mA na ntụtụ Arduino nwere ike ịnye nke a ugbu a, enwere ike jikọọ modul a ozugbo na Arduino. Ọ bụrụ na ọ dị mkpa karịa 40mA, njikọ aka na Arduino ga-emebi Arduino. N'okwu ahụ, ịkwesịrị iji onye ọkwọ ụgbọ ala iji jikọọ modul laser na Arduino.
Nzọụkwụ 1: sekit
Sekit na-esonụ na-egosi otu ị ga-esi jikọọ Arduino na modul a. Jikọọ wires otú ahụ.
Nzọụkwụ 2: Koodu
Bulite koodu ndị a na Arduino.
/*
Emere ya na 18 Nov 2020
Nke Mehran Maleki @ Electropeak
Ụlọ
*/
ntọala efu( ) {
pinMode (7, OUTPUT);
}
loop efu( ) {
digitalWrite (7, ELU);
igbu oge (1000);
digitalWrite (7, LOW);
igbu oge (1000);
}
Arduino
Detuo
Na koodu a, anyị na-ebu ụzọ tinye nọmba Arduino pin 7 dị ka mmepụta, n'ihi na anyị ga-eji ya ejikwa laser. Mgbe ahụ, anyị na-agbanye ma gbanyụọ laser ọ bụla sekọnd.
Na-ebugote koodu n'elu, laser ejikọrọ na Arduino ga-agbanye ma gbanyụọ kwa sekọnd ọ bụla.
Akwụkwọ / akụrụngwa
 |
ARDUINO KY-008 Laser Transmitter Module [pdf] Akwụkwọ ntuziaka onye ọrụ KY-008 Laser Transmitter Module, KY-008, Module Nnyefe Laser, Module Nnyefe, Module |
