ICP DAS PMC-5151 Power Meter Concentrator User Guide

Contents hide

1 PMC-5151 Quick Start

2 Supported Models

3 Technical Support

4 What’s in the box?

5 1 Configuring the Boot Mode

6 2 Connect to PC, Network and Power

7 3 Using Browser to Assign a New IP

8 4 Go to PMC-5151 Web Site for Power Management

9 Documents / Resources

9.1 References

10 Related Posts

PMC-5151 Quick Start

Supported Models

PMC-5151

Technical Support

PMC-5151 User Manual and Firmware:
• http://pmms.icpdas.com/en/download.html
• ftp://ftp.icpdas.com/pub/cd/pmc_cd/pmc-5151/

PMC-5151 Official Website:
• http://pmms.icpdas.com/en/PMC_5151.html

What’s in the box?

The package includes the following items:

PMC-5151 microSD card Screw Driver

Pin Terminal* 16

1 Configuring the Boot Mode

Before starting PMC-5151 at the first time, be sure that the switch is placed in the “0” position.

The rotary switch must be placed in the “0” position

2 Connect to PC, Network and Power

The PMC-5151 is equipped with an RJ-45 Ethernet port for connection to an Ethernet hub/switch and PC. You can also link directly the PMC-5151 to PC with an Ethernet cable.

3 Using Browser to Assign a New IP

The PMC-5151 is an Ethernet controller, which comes with a default IP setting; therefore, you must first assign a new IP setting to the LAN1 port of PMC. The factory default IP settings of PMC are as follows:

Item	Default
IP Address	192.168.255.1
Subnet mask	255.255.0.0
Gateway	192.168.0.1
DNS Server	8.8.8.8 (Default: Google DNS Server)

Follow the following steps for PMC-5151 new IP setting:
Step1: Change the PC’s IP setting as following.

IP: 192.168.255.10
Subnet mask: 255.255.0.0

Gateway address: 192.168.0.1

Step2: Make sure the PC and PMC(LAN1) is connecting through Ethernet.
Step3: Open a PC side browser, and type in the URL address (http://192.168.255.1) of the PMC to connect the Web Server in PMC.
Step4: Use default Administrator password “Admin” to login the system.

Step5: Please follow the sequence【System Setting】→【Network Setting】→【Network Setting(LAN1)】to change the IP setting of PMC.

Step6: After complete the IP setting, please save it, and then the new IP setting will take effect.

4 Go to PMC-5151 Web Site for Power Management

Please follow the steps below to build a power monitoring and management applications with ICP DAS PMC-5151 & Power Meter.

Step 1: Open a browser, and type in the URL address of the PMC

Open a browser and type in the URL address(The new IP setting) of the PMC in the address bar. Make sure the IP address is accurate.

Step 2: Get on the PMC web site

Get on the PMC web site. Complete the PMC setting in the order: 【Login】→【System Setting】→【Meter / Module Setting】→【Rule Setting】→【Save】for a power monitoring and management application.