Hytera PNC360S Push-to-Talk Over Cellular Radio
Product Overview
Before Use
Installing the Nano SIM Card
- Remove the battery cover with a proper tool.
- Open the SIM card slot cover.
- Install the SIM card.
- Put the card slot cover back in place.
Attaching the Battery
Attach the battery as shown below, and then attach the battery cover back.
Attaching the Belt Clip 
Attaching the Audio Accessory
Open the audio jack cover, and then insert the audio accessory into the jack.
NOTE: To ensure optimum waterproof and dustproof performance, close the audio jack cover after disconnecting the audio accessory.
Charging the Battery
CAUTIONS
- Use the approved charger to charge the battery.
- Read the Safety Information Booklet before charging.
- The remaining lithium-ion battery power is limited to 30% pursuant to the new lithium battery shipment regulation approved by the International Air Transport Association (IATA).
Before initial use, charge the battery.
To charge the battery, connect the product to a power adapter, power bank, or computer with the USB cable. To determine the charging status, check the battery icon shown on the LCD display.
Basic Operations
Turning on/off the Product
- To turn on the product, long press for two seconds.
- To turn off the product, long press for two seconds, and then select Power off.
Adjusting the Volume
To increase the volume, press the Volume + key. To decrease the volume, press the Volume – key.
Locking/Unlocking the Screen
- 1. To lock the screen, go to Settings > Screen locked to enable the feature. If the product is not operated for a specific duration, the screen will be automatically locked.
- 2. To unlock the screen, press
Connecting to the Network
To connect to the cellular network, install the Nano SIM card and activate the cellular data service.
Checking the Device Information
To check the information such as model, serial number, and version, go to Settings > About phone.
PoC Services
You can use Push-to-Talk over Cellular (PoC) services such as one-to-one or one-to-many voice call over the public network.
- To initiate a call, do as follows.
- Select a contact.
- Press and hold the PTT key, and then speak.
- Release the PTT key.
- You can receive a call without any operation.
Specifications
| Specifications | ||
| Model | PNC360S | |
|
Frequency Range |
l FDD-LTE: B1/B3/B7/B8/B20/B28
l TDD-LTE: B38/B40 l WCDMA: B1/B3/B8 l GSM: 900/1800 l BT: BT4.2 l WIFI: 2.4GHz, 802.11b/g/n20/n40 l GPS: GPS/Galileo/GLONASS/BeiDou |
|
|
Tx Power |
l GSM900: 32.5dBm
l DCS1800: 29.5dBm l WCDMA B1/B3/B8: 24dBm l FDD-LTE (B1/B3/B7/B8/B20/B28): 24dBm l TDD-LTE (B38/B40): 24dBm l BT: 3dBm l WIFI: 17dBm |
|
| Operational Temperature |
-20°C to +60°C |
|
| Battery Charging Temperature |
10°C to +45°C |
|
| Software Version | V1.0.01.000.02 | |
| Hardware Version | V1.00 | |
| Accessories | Adaptor, Belt Clip, Battery | |
|
Trademark |
||
| Adapter Model | S010WV0500200 | |
| Adapter Input | 100-240V~50/60Hz 0.4A | |
| Adapter Output | 5.0V/2.0A | |
|
Battery Caution |
CAUTION
Risk of explosion if the battery is replaced by an incorrect type |
|
| Specifications | ||
| disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion;
leaving a battery in an extremely high temperature surrounding environment that can result i n an explosion or the leakage of flammable liquid or gas; a battery subjected to extremely low air pressure that may result in an explosion or the leaka ge of flammable liquid o gas |
||
Documents / Resources
 |
Hytera PNC360S Push-to-Talk Over Cellular Radio [pdf] Instructions PNC360S, Push-to-Talk Over Cellular Radio, PNC360S Push-to-Talk Over Cellular Radio |
