Controller Adapter for N64° Controller
QUICK START GUIDE
Compatibility switch
Using the Adapter with Your Console
The Controller Adapter allows you to switch between
Console mode and PC/Mac® mode. Make sure that your anode is configured before plugging your adapter into a evince.
Console Mode for Nintendo Switch®
- Make sure the compatibility switch on your adapter is set to CONSOLE Mode.
- Plug in your controller for N64° into the adapter controller port.
- Insert the USB end of the adapter into a free port on your dock.
Note: Controller inputs and functionality may vary depending on game compatibility. The Controller Adapter is not compatible with extension port accessories.
You can enable alternate button layouts by holding either the L button, R button, L and R buttons, C-Up button, C-Down button, C-Right button, or C-Left button on your controller as you insert your adapter into a USB ort on your dock. If you do not hold down any of the buttons, your button layout will be in the default layout.
- You can also change your inputs in your game’s settings if your game allows it.
- The remapping function only works when plugging in the adapter. If you switch controllers via the controller port on the adapter, the button layout will not change.
- Unplugging the adapter from the dock, turning off Hour console, or your console going into Sleep mode we cause the button input remapping to revert to the default layout.
PC / Mac® Mode
- Make sure the compatibility switch is set to PC Mode.
- Plug in your controller for N64° into the adapter controller port.
- Insert the USB end of the adapter into a free USB port on your PC or Mac®.
- Make sure to configure your controller inputs via the game settings. Setup and functionality may vary expending on your device.
Note: You can also enable alternate button layouts by holding either the L button, R button, L and R buttons, C-Up button, C-Down button, C-Right button, or C-Left button on your controller as you insert your adapter into a USB port on your computer. The Controller Adapter is not compatible with extension port accessories.
For troubleshooting, contact us at Support@Hyperkin.com.
Statement of Compliance with EU Directive
Hyperkin Inc., located at 1939 West Mission Blvd,
Pomona, CA 91766, declares under our sole responsibility that the product, Controller Adapter for N64° Controller Compatible with Nintendo Switch®/PC/Mac®, is in compliance with the essential requirements and other relevant provisions of Low Voltage Directive (LVD) 2014/35/EU, RoHS Directive 2011/65/EU, and carries the
CE marking.
The full Declaration of Conformity can be requested by emailing:
Email: compliance@hyperkin.com
Company Name: Hyperkin Inc.
Address: 1939 West Mission Blvd, Pomona, CA 91766
© 2020 Hyperkin Inc. Hyperkin® is a registered trademark of Hyperkin Inc. Nintendo
Switch® and N64® are registered trademarks of Nintendo® of America. Mac® is a
registered trademark of Apple Inc. This product is not designed, manufactured,
sponsored, endorsed, or licensed by Nintendo® of America Inc. nor Apple Inc. in the
United States and/or other countries. All rights reserved. Made in China.
Documents / Resources
 |
HYPERKIN N64 Controller Adapter [pdf] User Guide N64, N64 Controller Adapter, Controller Adapter, Adapter |