HOTONE GP-5 Multi Effects Processor User Guide

HOTONE GP-5 Multi Effects Processor

Thank you for purchasing a VALETON product!
X In the interest of product improvement, the specifications and/or the content of products (including but not limited to appearances, packaging design, manual content, accessories, size, parameters and display screen), are subject to change without prior notice. Please check with local supplier for exact offers, Specifications and features (including but not limited to appearances, colors and size) may vary by model owing to environmental factors, and all images are illustrative.

Panel Introduction

1. IN Jack
   1/4″ (6.35mm) mono input connection for guitar or other instruments.
2. OUT/PHONES Jack
   1/4″ (6.35mm) TRS stereo unbalanced output connection, compatible with headphones. When connecting a mono device such as a guitar amp or another pedal, a TS cable is sufficient.
3. VOL Knob
   Turn to control GP-5’s main output volume.
4. PARA Knob (with enter button)
   On the main display screen, turn to switch patches, press to enter global settings, and hold to toggle BT wireless function on/off.
5. LCD Display
   Color LCD shows GP-5’s patch numbers, patch names, and other operation information.
6. Footswitch
   Use to change patches, turn on/off effects, or bypass GP-5. On the main display screen, hold the footswitch to enter the tuner.
7. USB Jack
   IJSB 2.0 Type-C port to connect to a computer for data transfer or as an audio interface, and it can also be connected to a mobile phone for as an audio interface. Furthermore, it allows for the connection of a
   USB power adapter or power bank to provide power to the GP-5.
8. DC SV Jack
   5.5 x 2.1mm DC 9V, IOOmA,

Specifications

• A/D/A Converter: 24-bit high performance audio
• Supported Sample Rate: 44.1kHz
• SNR: IOOdB
• Module: 10, up to 9 modules can be used simultaneously.
• Patch Memory: 100 Patch slots, 50 Factory Patches
• Analog Input Connection
  • IN: 1/4′ (6.35mm) TS jack, 1M Ohms
• Analog Output Connection
  • OUT/PHONES: 1/4″ (6.35mm) TRS stereo unbalanced jack, 100 Ohms
• Digital Connections
  • USB Port USB 2.0 Type-C Port
• USB Recording Specification
• Sample Rate: 44.1kHz
• Bit Depth: 16-bit
• Size and Weight
  • Dimensions: 92mm (W) x 44.6mm (D) x 50.5mm (H)
  • Unit Weight: 250g
• Power
  • DC 9V Power Requirements: 5.5 x 2.1mm, 100mA,
  • USB Power Requirements: DC 5V, 190mA

Scan the QR code for the full manual G GP-5 software. www.valeton.net

Product Multi-Effects

• Model Number: GP-5
• FCC ID: 2AHJS-GP5
• CMIIT 10:
• IC: 30142-GP5
• HVIN: GP-5
• Polarity:
• Adapter: 9v 0.1A

FCC Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation

Any Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC RI-des These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equiprnent off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio TV technician for help.

This equipment complies with FCC exposure If nits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator your body.

FCC 10: 2AHJS-GP5

IC Caution

Radio Standards Specification RSS-Gen, issue 5
This device contains licence-exempt transmitter (s)/receiver (s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS (s).

RF exposure statement:
The equipment complies with IC Radiation exposure limit set forth for uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.