HOMCOM B31-507V90 3d Printed Table Lamp
IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY.
Installation Statement
- Please read the instruction manual carefully before installation and follow the instructions.
- To avoid the risk of electric shock, please make sure to turn off the power before installation and maintenance.
- This lamp is only suitable for indoor installation (not for wet environments).
Components
Installation diagram
- Step 1
Keep the power off and install the light source properly. - Step 2
Secure the lampshade to the base.
- Step 3
Plug in the power cord and turn on the switch, and enjoy the artistic atmosphere created by the 3D printed lamp.
Precautions
Warning
Do not modify the lamp or replace its parts at will to avoid accidents such as electric shock and fire.
Attention
- Please use the lamp within the allowed voltage range. Using it with a voltage higher than the specified value may cause the lamp to burn out and lead to accidents such as fires.
- This lamp is a general indoor lamp. Please do not use it in direct sunlight, damp places, or areas where corrosive gases are generated.
- The light source of this lamp is replaceable. When the light source reaches the end of its lifespan, simply replace the light source of the lamp.
- Do not apply excessive force to the lamp, as it may cause damage.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
Maintenance and Repair
- When the lamp needs to be cleaned, please first unscrew and remove the lampshade. Wipe it with a soft cloth dampened with clean water and wrung dry, and then dry it with a dry cloth.
- Do not use detergents, organic solvents, or insecticides to wipe or spray on the lamp. This may cause discoloration, deterioration, reduced strength, or damage to the lamp.
UK
If you have any questions, please contact our customer care center.
Our contact details are below:
IMPORTER ADDRESS:
- MH STAR UK LTD
- Unit 27, Perivale Park,
- Horsenden lane South
- Perivale, UB6 7RH
- MADE IN CHINA
Frequently Asked Questions
What should I do if the supply cord is damaged?
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons to avoid hazards. Do not attempt to use the product with a damaged cord.
Where can I find the importer's address?
The importer's address is provided as follows: MH STAR UK LTD, Unit 27, Perivale Park, Horsenden Lane South, Perivale, UB6 7RH, Made in China
Can I clean the product with water?
It is recommended to use a damp cloth for cleaning the exterior of the product. Ensure the product is unplugged before cleaning.
Documents / Resources
 |
HOMCOM B31-507V90 3d Printed Table Lamp [pdf] Instruction Manual B31-507V90 3d Printed Table Lamp, B31-507V90, 3d Printed Table Lamp, Printed Table Lamp, Table Lamp, Lamp |