Quick Installation Guide

Introduction

This Quick Installation Guide contains important information and notes regarding the installation of Philips MasterConnect LED GU10s. Please read carefully before installation.

The Philips MasterConnect LED GU10 is a smart lighting product designed for wireless control and integration into smart home systems.

Key Features & Installation Notes

• Product is dimmable by wireless control. DO NOT use with a wall dimmer.
• Operate with direct mains only.
• Product must be used in dry environments and in luminaires that are approved for the application.
• Operating ambient temperature from -20°C to +45°C.
• Must be used with compatible control devices.
• Product should be used within the specified radio-frequency (RF) communication range. This range can vary depending on the actual application environment.

Installation and Setup

Follow the instructions below to install the product(s). Different systems may require physical installation of devices at a different stage during system setup. You are required to read the system guide to understand the complete and proper sequence.

After power on, lamps will automatically search for an available Zigbee network and connect to a Zigbee gateway (if any). Lamps can also be commissioned by using a designated Bluetooth mobile application. Please refer to our website for instructions on app download.

[Image of a Philips MasterConnect LED GU10 bulb]

Factory Reset

When needed, performing a factory reset will restore a lamp to its default state. The lamp will be removed from its current network (if any) and all settings will be deleted.

1. The lamps can be reset from the system app when credentials are properly kept and lamps are accessible. In this case, please follow the in-app instructions.
2. If credentials are lost, lamps will need to enter safe-mode in order to be reset. Turn the lamps off for 5 seconds, then on for 5 seconds. Repeat 5 times to activate safe mode. Visit our website to download the tool for factory reset.

Technical Specifications & Compliance

Hereby, Signify declares that the radio equipment is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.philips.com/lighting

• Wireless RF mode Frequency Range: Bluetooth Low Energy: 2402-2480 MHz, Zigbee: 2405-2480 MHz
• Output power (Conducted): Bluetooth Low Energy: 4dBm, Zigbee: 4dBm

The Bluetooth® word and logos are registered trademarks owned by Bluetooth SIG, INC.

Disposal Information

Please inform yourself about the local waste disposal, separation, and collection system for electrical and electronic products and packaging. Please act according to your local rules and do not dispose of your old product and packaging with your normal household waste. The correct disposal of the packaging, your product and/or batteries will help prevent potential negative consequences for the environment and human health. Batteries should be disposed of separately from the municipal waste stream via designated collection facilities. When disposing of a product that contains non-user replaceable batteries, the non-user replaceable batteries shall be removed by a professional.

Interact Ready logo