Product Overview and Features
The edelkrone Wired Signal Hub is an accessory designed to expand connectivity for edelkrone motion control systems, specifically the MOCO series.
Hub Diagram Description: The central unit features six 3.5 mm link ports, labeled 1 through 6. Ports 1, 2, and 3 are positioned on one side, while ports 4, 5, and 6 are on the opposite side. The hub allows for the connection of up to 5 edelkrone motion control units, supporting a configuration of 1 output and 5 inputs. All ports can be utilized as either input or output.
A 'Strap Slot' is integrated into the device for mounting purposes.
Compatibility Note: The Wired Signal Hub is exclusively compatible with edelkrone motion control units that are equipped with a 3.5 mm link port.
Attaching Wired Signal Hub to Tripod
The hub comes with a non-slip tripod attachment strap for secure mounting.
Attachment Process: Simply wrap the strap around the tripod leg. Slide the strap through the designated slot on the hub. Once threaded, pull the strap tight to ensure a secure fit.
Tripod Leg Diameter Compatibility:
- Maximum: 40 mm
- Minimum: 20 mm
Box Contents
- Wired Signal Hub
- 3.5mm male to male Link Cable (2m) (5 pcs.)
Disclaimer
Product Disposal: If the product becomes damaged beyond repair or if you wish to dispose of it, it must be disposed of separately from the general municipal waste stream. Utilize designated collection facilities appointed by the government or local authorities. Always observe the regulations of your area and country concerning the disposal of electronic products.
Safety and Usage Warnings:
- Never force a different type of connector into a port.
- Never use or store the Wired Signal Hub in areas subject to extreme temperatures or high levels of vibration.
- Avoid dropping or causing physical damage to your Wired Signal Hub.
edelkrone cannot be held responsible for damage caused by improper use or modification of the product.
[disposal symbol]
