HILTI MFP-SA Fixed Point Compact
Introduction
This document provides detailed instructions for the installation of the Hilti MFP-SA M20 system, including necessary components and steps.
Components
- MFP-SA M20 #2460490
- M12×25 Bolt #2184553
- MFP-PC 73-78 to 318-326
Specifications
| Component | Specification |
|---|---|
| MFP-SA M20 | #2460490 |
| M12×25 Bolt | #2184553 |
| MFP-PC | 73-78 to 318-326 |
Installation Instructions
- Measure the length (L) and calculate X as L + 60 mm.
- Position the MFP-PC clamp on the pipe.
- Attach the MFP-SA M20 bracket to the structure using the M12×25 bolt.
- Ensure the bracket is securely fastened.
- Align the components as shown in the diagrams.
- Tighten all bolts to the specified torque.
- Verify the installation is secure and stable.
Important Notes
All other parts in the design, other than MFP-SA and MFP-PC, should be calculated separately.
Diagrams
The diagrams illustrate the step-by-step installation process, showing the correct positioning and alignment of components.
FAQ
- What is the purpose of the MFP-PC?
The MFP-PC is used to clamp the pipe securely in place. - How do I calculate the correct length for installation?
Calculate X as the length (L) plus 60 mm. - Are there any additional parts required?
All other parts must be calculated separately as per the design requirements.
Documents / Resources
 |
HILTI MFP-SA Fixed Point Compact [pdf] Installation Guide MFP-SA M20, MFP-PC 73-78, 318-326, MFP-SA Fixed Point Compact, MFP-SA, Fixed Point Compact, Point Compact, Compact |