hidalite - logoLEDstrip 24V Line Opal IP67
Artnr: IM00507 Version: 2022/03

hidalite 7506952 Led String of Lights Ledstrip Rx Line 24v Ip67 Opal Mid -

hidalite 7506952 Led String of Lights Ledstrip Rx Line 24v Ip67 Opal Mid - Recycle

E-n Snro El.nr GTIN Length Max.Length LED color LED/m Output maxim Voltage DC
7506952* 4143592 3216632 7392971140049 5m 5m 2700K 512pcs lOW 24V
7506953 4143593 3216633 7392971140056 rm 5m 2700K 512pcs lOW 24V
7506954* 4143594 3216634 7392971140063 5m 5m 3000K 512pcs 10W 24V
7506955 4143595 3216635 7392971140070 rm 5m 3000K 512pcs 10W 24V
7506956* 4143596 3216636 7392971140087 5m 5m 4000K 512pcs lOW 24V
7506957 4143597 3216637 7392971140094 rm 5m 4000K 512pcs 10W 24V

SAFETY INSTRUCTIONS

Read these instructions carefully before commencing installation and retain for future reference. The luminaire should be installed by a licensed electrician and in accordance with local regulations. Make sure that the power is off before installation or maintenance.

  • The installation should be performed by a qualified electrician.
  • See the table of technical specifications and follow the instructions to perform the installation in a safe and correct manner; note the recommendations for maximum lengths.
  • Make sure that the LED strip’s voltage corresponds with that of the drive unit and ensure that the polarity is correct.
  • When two or more LED strips are interconnected, make sure the maximum recommended length is not exceeded.
  • Make sure the power is switched off during installation and that the LED strips do not overlap to avoid overheating.
  • It is important that the LED luminaire’s maximum specified ambient temperature is taken into consideration in order to guarantee its life span, if this is exceeded, the life span can be shortened drastically.
  • Use the recommended/approved assembly fittings to ensure the lifespan of the LED strip.
  • The LED strip must not be switched on when rolled up.
  • LEDs are sensitive components and must be treated with care and not subjected to mechanical stress.
  • The flexible LED strip must not be bent more than the recommended bending radius.
  • The LED chip should not be exposed to direct sunlight when switched on.
  • The double-sided adhesive tape is for installing the lights, but may need to be complemented with heat-resistant silicone. When installed in the profiles (not uplight) recommends heat-resistant silicone for a permanent and sustainable installation. Do not apply silicone directly on the LED chip but along the sides.

We reserve the right to change specifications at any time.

Installation – End cap

hidalite 7506952 Led String of Lights Ledstrip Rx Line 24v Ip67 Opal Mid - End cap

Elektro Elco AB, Tallvägen 5, SE-56435 Bankeryd, Sweden | info@elco.se | www.hidealite.se | www.hidealite.uk | www.hidealite.fi | www.hidealite.no | www.hidealite.dk

hidalite - iconFor explanation of symbols see www.hidealite.se
Find your Profilehidalite - qrSuitable profiles
at www.hidealite.com

Documents / Resources

hidalite 7506952 Led String of Lights Ledstrip Rx Line 24v Ip67 Opal Mid [pdf] Instructions
7506952 Led String of Lights Ledstrip Rx Line 24v Ip67 Opal Mid, 7506952, Led String of Lights Ledstrip Rx Line 24v Ip67 Opal MidLedstrip Rx Line 24v Ip67 Opal Mid, Ip67 Opal Mid

References

Leave a comment

Your email address will not be published. Required fields are marked *