HERCULES DJControl Inpulse T7 2-Deck Motorized DJ Controller 

INSTALLATION

1. PDF versions:
   https://support.hercules.com
2. Contents
   
   You need a Philips cross screwdriver
   
   
3. Unplug T7 power and USB cables. Remove volume & crossfader caps
   
4. Remove 4 torx screws, with the torx key
   
5. Remove metal plate
   
6. Remove Philips (cross) screws
   
7. Remove plastic plate over faders
   
8. Remove the faders 9 power cable
   
9. Remove 4 screws from fader board
   
10. Remove standard fader circuit board
    
11. Take premium fader (black) board
    
12. Place premium fader module in T7
    
13. Insert power cable
    
14. Add 4 philips (cross) screws
    
15. Place the cover
    
16. Add 2 philips (cross) screws
    
17. Fix premium plate with 4 torx screws
    
18. Before calibrating faders
    Make sure DJ Control Impulse T7 firmware version is at least 1.87 / Top 1.24
    Info in Hercules drivers Control panel > About.
19. Calibrate faders.
    Connect T7 power and
    USB cables.
    Press down deck 2
    Back and Range keys while you switch on T7 power.
    Release Back & Range keys.
20. Beatmatch guide
    key blinks 2 FX keys light on: 1 & 2.
    Move both volume faders on top.
    Move crossfader on middle position.
21. Press Beatmatch guide key once. 
    2 more FX keys light on: 3 & second 1.
    Move the 2 volume faders to min & max position 2 times.
    Move crossfader fully to left + fully to right.
22. Press Beatmatch guide key once again.
    All FX keys are lit. The calibration is finished
23. Infos & tutorial on
    https://support.hercules.com/T7Maintenance
    

Documents / Resources

HERCULES DJControl Inpulse T7 2-Deck Motorized DJ Controller [pdf] Instruction Manual DJControl Inpulse T7 2-Deck Motorized DJ Controller, Inpulse T7 2-Deck Motorized DJ Controller, 2-Deck Motorized DJ Controller, Motorized DJ Controller, DJ Controller, Controller

References

• User Manual