HELMOUNTS B09NGQM4Z7 Action Camera Mount

HELMOUNTS B09NGQM4Z7 Action Camera Mount

What’s in the Box

Products Included:

  • Action Camera Mount
    What’s In The Box
  • Isopropyl Alcohol Prep Pads
    What’s In The Box
    Optional Equipment for Faster Installation Times:
  • Heat Gun (Not Included)
    What’s In The Box
  • Tape Primer (Sold Separately)
    What’s In The Box

Installation can be done in three separate ways for any mount: 

  1. Installation without any additional application.
  2. Installation with heat gun application (faster adhesion).
  3. Installation with tape primer application (Recommended/fastest adhesion).

Note. Only one of the three installations is needed.

Installation Procedure

Step 1. Clean the helmet’s surface with the given isopropyl alcohol prep pads and let the surface dry.

  • Chin
    Installation Procedure
  • Right
    Installation Procedure
  • Left
    Installation Procedure
  • Top
    Installation Procedure
  • Rear
    Installation Procedure

Step 2. Follow the appropriate step based on the desired application process as shown below.

Installation without any additional application. Peel off the plastic cover of the tape and place the mount on the helmet’s appropriate surface. Continue with Step 3.

Installation Procedure

Installation with heat gun application. Peel off the plastic cover of the tape and apply heat with a heat gun (not included). Wait for the tape’s surface to heat up. Place the mount on the helmet’s appropriate surface. Continue with Step 3.

Installation Procedure

Installation with tape primer application. Peel off the plastic cover of the tape. Grab the tape primer (sold separately) and apply pressure on the dot location indicated as “Crush at dot” on the tape primer until it breaks. Apply a single coat of the primer on the helmet’s appropriate surface. At time of application, make sure the room temperature is 60°F – 80°F (15°C – 27°C). Place the mount on the helmet’s appropriate surface. Continue with Step 3.

Installation Procedure

Step 3. Apply pressure for at least 1 minute towards the helmets surface and release. Note, follow
Table 1 → Application → None / Heat / Tape Primer (page 6), to know the appropriate times to leave
the mount resting in order to ensure proper adhesion between the mount and the helmet.

  • Chin
    Installation Procedure
  • Right
    Installation Procedure
  • Left
    Installation Procedure
  • Top
    Installation Procedure
  • Rear
    Installation Procedure

Additional Information

Table 1 – Resting Times for Proper Adhesion

Application  Resting Time  Adhesion %
None 24 hrs 90
Heat 2 hrs 100
Tape Primer 30 min 100

Customer Support

www.helmounts.com

Logo
Logo

Documents / Resources

HELMOUNTS B09NGQM4Z7 Action Camera Mount [pdf] Installation Guide
B09NGQM4Z7 Action Camera Mount, B09NGQM4Z7, Action Camera Mount, Camera Mount, Mount

References

Leave a comment

Your email address will not be published. Required fields are marked *