MATRIX COLOR
User Guide
Safety Instructions
- DO NOT look into the light source. Be cautious of the high-intensity beam.
- DO NOT disassemble Matrix Color. This will void the warranty.
- DO NOT install Matrix Color in damp or wet locations.
- DO NOT obstruct the fixture’s air vents.
- Use safety cable (not included) when rigging Matrix Color overhead.
- Only use Fiilex approved power supply and accessories. Failure to do so may damage the fixture.
- Shields, lenses or ultraviolet screens shall be changed if they have become visibly damaged to such an extent that their effectiveness is impaired, for example by cracks or deep scratches.
- The lamp shall be changed if it has become damaged or thermally deformed.
- The luminaire is intended for professional use only.
Parts Diagram
| 1. Handle 2. Top Latch 3. Yoke Bolt 4. Tilt Lock Lever 5. Yoke 6. Baby/Junior Pin Receiver 7. Mount Tightening Knob 8. Vent Holes |
9. Buttom Latch 10. Power Supply Unit (PSU) 11. Fan Intake Vent 12. Intensity Control Knob 13. CCT/HUE Knob 14. GN/SAT Knob 15. USB Type-A Port (5V/1A Power) 16. Dual Locking V-Mount |
17. DMX Iutput (XLR-Male 5-pin) 18. OLED Display 19. Navigation Pad 20. ON/OFF Switch 21. USB Type-C Port (For updating firmware) 22. LAN Port 23. DMX Output (XLR-Female 5-pin) 24. DC Input Port |
Fixture Operation
- Mode Selection
Use Navigation Pad
to enter MODES, then navigate through modes and select the desired mode.
- Fixture Control
1 Manual / Local :
Use Intensity Control Knob and/or the Navigation Pad to control the parameters.
For CCT modes and HSI modes, use either CCT/HUE Knob and GN/SAT Knob or the Navigation Pad .
2 DMX / RDM / Ethernet (ArtNet / sACN) :
Display shows DMX connection status, NO DMX or DMX OK.
Settings
Use Navigation Pad to enter and edit SETTINGS. Navigate to the right to access additional settings.
- Fan speed options
Off The fan is completely off. (Operation time is limited.) Variable The fan speed varies based on light intensity. Silent The fan operates at reduced speed. Full Speed The fan operates at full speed. - Dimming options
Sharp Best for flash and strobe effects. Smooth Best for gradual fades. - Ethernet
Modify ArtNet and sACN settings of the fixture.
- Info
View current fixture firmware versions and fixture temperature.
1689 Regatta Blvd. Richmond, CA 94804 | 510-620-5155 | fiilex@fiilex.com
www.fiilex.com
Documents / Resources
 |
Fiilex FLXMXCLR-Z Matrix Color [pdf] User Guide FLXMXCLR-Z Matrix Color, FLXMXCLR-Z, Matrix Color |
