Lightning HV3277T-BLK-12V Virsma Step Light
Instruction Manual
Virsma Step Light Installation Instructions
| Model No. | HV3277T-BLK-12V | HV3277T-WHT-12V | |
| Name | Visma | ||
| Material | Aluminum | ||
| Colour | Black | White | |
| IP Rating | IP54 | ||
| Input Voltage | 12v DC | ||
| Lamp Base | Built-in LED | ||
| Lamp Wattage | lx 4w | ||
| Colour Temp | TRI Colour – 3000k, 4000k, 5500k | ||
| Lumens | 110Im, 1151m, 1201m | ||
| CRI | > 80 | ||
| Wiring | Parallel | ||
| Dimmable | No | ||
| Warranty | 2 Years Replacement |
Important Safety Issues:
- This product must be installed by a qualified electrician according to AS/NZS 3000.
- Ensure all electrical mains are disconnected before any installation.
- Do not exceed maximum wattage restrictions for globes: 240V GU10 = 35w / 12V MR16 = 20w
- Modification of this product will void any warranty.
- Havit Lighting does not take responsibility for wrong installation, incorrect use, or use of installation material that does not belong to the system.
- When installing low voltage fittings, Voltage to fitting must be within +or- 5% of voltage required and cannot be installed more than 25m from LED Driver, if not within this allowance warranty will be voided.
- Aluminum and 304SS fittings must not be installed within 2km of any saltwater environments.
- When installing copper fittings, gloves must be worn to avoid any oils transferring to the fitting.
- All 316 stainless steel fittings must have regular cleaning maintenance to avoid any tea staining from forming on the fitting. (Warranty does not cover Tea Staining)
- All o-rings and seals must be in place correctly to maintain the warranty.
- These instructions may be updated at any time due to product improvements, Please visit the website for the most current installation instructions.
Steps for Installation:
- Make sure that the electrical circuit is free of voltage (master switch off )
- Loosen Allen screws on side of the fitting and remove the face and set it aside.
- Install base plate to the wall in the desired location
- Using an appropriate 12v DC LED Driver – DO NOT CONNECT LIGHT FITTING DIRECTLY TO 240V
- Connect the cable – If more than one fitting is installed, wiring must be done in parallel.
- Fitting is preset to 3000k, to change the slide switch to desired color temperature
- Reattach face to base plate making sure Allen screws are tight to avoid water penetration
- Apply silicon around the edge of the fitting to prevent any water from getting inside to electrical connections.
- All connections must be carried out carefully, inspect all contacts before switching back on the electric circuit.
Must be installed by a licensed electrician
Contact Details:
| 143 Beauchamp Road Matraville NSW 2036 Australia |
Tel: 02 93818300 Fax: 02 9666 8881 Email:sales@havit.com.au Web:www.havit.com.au |
Documents / Resources
 |
HAVIT Lightning HV3277T-BLK-12V Virsma Step Light [pdf] Instruction Manual HV3277T-BLK-12V, HV3277T-WHT-12V, HV3277T-BLK-12V Virsma Step Light, HV3277T-BLK-12V, Virsma Step Light, Step Light, Light |
