Havit-Lighting-LOGO

Havit Lighting RGBCW LED Strip Touch Panel Controller

Havit-Lighting-RGBCW-LED-Strip-Touch-Panel-Controller-PRODUCT

Important: Read All Instructions Prior to Installation

Function introduction

Havit-Lighting-RGBCW-LED-Strip-Touch-Panel-Controller-FIG-1 Havit-Lighting-RGBCW-LED-Strip-Touch-Panel-Controller-FIG-2

Product Data

     DC Version                                                 AC Version

Output Signal RF signal RF signal
Power Supply 12-24VDC 100-240VAC
Power consumption < 20 mA < 15 mA
Operating temperature 0-40°C 0-40°C
Relative humidity 8% to 80% 8% to 80%
Dimensions 75x120x29.1mm 75x120x29.1mm
  • Touch-sensitive
  • Glass interface(white & black)
  • Compatible with all universal series RF receivers, radio frequency: 916.5MHz
  • Control RGB+CCT color
  • Control 1 zone of RF receiver
  • Waterproof grade: Ip20

Safety & Warnings

  • DO NOT install with power applied to device.
  • DO NOT expose the device to moisture.

Wiring diagram

Havit-Lighting-RGBCW-LED-Strip-Touch-Panel-Controller-FIG-3

Operation

  1. Do wiring the wall panel & RF receiver according to wiring diagram (please refer to the instructions of RF receiver that you would like to pair with)
  2. Power on, then touch the button Havit-Lighting-RGBCW-LED-Strip-Touch-Panel-Controller-FIG-4to turn on the controller, indicator of the controller turned blue

Pair with RF receiverHavit-Lighting-RGBCW-LED-Strip-Touch-Panel-Controller-FIG-5

Built-in 10 color-changing modes are as follows:

  • Mode 1: Any two colors of RGB mix fade-in & fade-out
  • Mode 2: RGB three colors mix fade-in & fade-out
  • Mode 3: RGB three colors mix fade-out & fade-in
  • Mode 4: RGB flash
  • Mode 5: RGB three colors fade-in & fade-out successively
  • Mode 6: RGB three colors fade-in successively
  • Mode 7: RGB three colors fade-out successively
  • Mode 8: RGB three colors jump changing successively
  • Mode 9: R&B two colors mix fade (R in B out), then G fade-in, then R&B mix fade (R out B in), then G fade-out
  • Mode 10: B fade-out, then G&B mix fade (G out B in), then R&G mix fade (R out G in), then R fade-in Havit-Lighting-RGBCW-LED-Strip-Touch-Panel-Controller-FIG-6

Installation

Havit-Lighting-RGBCW-LED-Strip-Touch-Panel-Controller-FIG-7

FAQ

How do I adjust the color temperature using the dual-color slider?
To adjust the color temperature between Warm White and Cool White, simply slide-touch the dual color slider on the controller.

How can I increase/decrease the light intensity of the RGB channels?
To adjust the light intensity of the RGB channels, press and hold down on the RGB slider to increase or decrease the intensity.

Documents / Resources

Havit Lighting RGBCW LED Strip Touch Panel Controller [pdf] Installation Guide
RGBCW LED Strip Touch Panel Controller, RGBCW, LED Strip Touch Panel Controller, Touch Panel Controller, Panel Controller, Controller

References

Leave a comment

Your email address will not be published. Required fields are marked *