HAVIT Lighting HV3288W-AB Stylez Step Light
Product Usage Instructions
- Ensure the product is installed by a licensed electrician for safety reasons.
- Refer to the Mounting Base Diagram for installation guidance.
- Make sure to follow all safety instructions provided in the manual.
- Select the appropriate model based on the desired material and color.
- The product is suitable for outdoor use with an IP65 rating.
- The input voltage is 12v DC.
- The lamp base is built-in LED.
- The lamp wattage is 1x 3w.
- Choose the desired color temperature between 3000k and 5500k.
- The product provides a brightness of 240lm to 250lm.
- The Color Rendering Index (CRI) is greater than 80, ensuring good color representation.
- The product is not dimmable.
- A warranty of 3 years replacement is provided.*
Product Specifications
| Model No. | HV3288W-AB | HV3288C-AB | HV3288W-BR | HV3288C-BR | HV3288W-GPH | HV3288C-GPH | HV3288W-BLK | HV3288C-BLK | HV3288W-WHT | HV3288C-WHT | HV3288W-SS316 | HV3288C-SS316 |
| Name | Stylez | |||||||||||
| Material | Brass | 316 Stainless Steel | ||||||||||
| Colour | Antique Brass | Brass | Graphite | Black | White | Stainless Steel | ||||||
| IP Rating | IP65 | |||||||||||
| Input Voltage | 12v DC | |||||||||||
| Lamp Base | Built in LED | |||||||||||
| Lamp Wattage | 1x 3w | |||||||||||
| Colour Temp | 3000k | 5500k | 3000k | 5500k | 3000k | 5500k | 3000k | 5500k | 3000k | 5500k | 3000k | 5500k |
| Lumens – V3288 | 240lm | 250lm | 240lm | 250lm | 240lm | 250lm | 240lm | 250lm | 240lm | 250lm | 240lm | 250lm |
| CRI | > 80 | |||||||||||
| Dimmable | No | |||||||||||
| Warranty | 3 Years Replacement* | |||||||||||
Dimensions
Mounting Base Diagram
Important Safety Issues
- This product must be installed by a qualified electrician according to AS/NZS 3000.
- Ensure all electrical mains are disconnected before any installation.
- Modification of this product will void any warranty.
- Havit Lighting does not take responsibility for wrong installation, incorrect use, or use of installation material that does not belong to the system.
- When installing low voltage fittings, Voltage to fitting must be within +or- 5% of voltage required and cannot be installed more than 25m from LED Driver, if not within this allowance warranty will be voided.
- When installing copper or brass fittings, gloves must be worn to avoid any oils transferring to fitting.
- All 316 stainless steel fittings must have regular cleaning maintenance to avoid any tea staining from forming on fitting. (Warranty does not cover Tea Staining)
- All o-rings and seals must be in place correctly to maintain warranty.
- These instructions may be updated at any time due to product improvements, Please visit website for most current installation instructions.
Steps for Installation
- Make sure that the electrical circuit is free of voltage (master switch off)
- Remove base plate from fitting by loosening allen screws on side of fitting.
- Install mounting bracket in desired location.
- Using an appropriate 12v DC LED Driver – DO NOT CONNECT LIGHT FITTING DIRECTLY TO 240V
- Connect the cable – If more than one fitting installed, wiring must be done in parallel.
- Strip back the cable on both fitting and cable run and twist the positive cables together. Then connect neutral cables together
- Solder all joins using solder and either a heat gun or butane gas torch.
- Cover connections using an adhesive lined heat shrink or gel cap to make connection watertight. Failure to do this will void warranty.
- Heat the heat shrink or crimp the gel cap making sure all connections are covered.
- Reattach fitting to base plate making sure allen screws are tight to avoid water penetration
- Apply silicon around edge of fitting to prevent any water from getting inside to electrical connections.
- All connections must be carried out carefully, inspect all contacts before switching back on the electric circuit.
Warranty Terms & Conditions*
Additional Information
Contact Details:
143 Beauchamp Road Matraville NSW 2036 Australia
Tel: 02 9381 8300
Fax: 02 9666 8881
Email: sales@havit.com.au
Web: www.havit.com.au
Documents / Resources
 |
HAVIT Lighting HV3288W-AB Stylez Step Light [pdf] Installation Guide HV3288W-AB, HV3288C-AB, HV3288W-BR, HV3288C-BR, HV3288W-GPH, HV3288C-GPH, HV3288W-BLK, HV3288C-BLK, HV3288W-WHT, HV3288C-WHT, HV3288W-SS316, HV3288C-SS316, HV3288W-AB Stylez Step Light, HV3288W-AB, Stylez Step Light, Step Light, Light |