HALCYON LogoEX330 USTSL
LED INGROUND

OUTLINE DIMENSION

HALCYON EX330 USTSL LED Inground

BOM

HALCYON EX330 USTSL LED Inground - HALCYON EX330 USTSL LED Inground

  1. Front cover
  2. Tempered glass
  3. Reflector
  4. Housing
  5. Cable gland
  6. Power cable

Unit: mm

  • Colour Temperature: 2700k
  • Input Voltage: 24V DC Constant Voltage (wire in parallel)
  • Ingress Protection Rating: IP67
  • The mounting sleeve and luminaire must be installed over a drained substrate e.g. Scoria so that the LED luminaire is never immersed in water for extended periods (See diagrams pg2)
  • To prevent voltage drop over a circuit total luminaire wattage plus voltage drop over the length of a cable run and cable gauge must be taken into account.
  • Always try to use a Constant Voltage Driver which is double the total circuit wattage.
  • Multistrand UV protected flex should be utilised for all exterior 24V DC CV circuits.
  • All cable joints must be a resin or IP68 type – NOTE: standard crimps, terminal blocks and PVC tape are not suitable cable joining methods.
  • Luminaire front faces are all electropolished 316 grade Stainless Steel.
  • Applicable environment temperature: -20°C …. +40°C
  • All installation work must be carried out by a registered electrician.

EX330 USTSL
MUST BE INSTALLED OVER A DRAINED SUBSTRATE

HALCYON EX330 USTSL LED Inground - Bom

Example of wiring

HALCYON EX330 USTSL LED Inground - Bom 1.

SPECIFICATIONS

Material specifications:

Housing: 12# die-casting grey powder coated aluminum, T=60-80um. adhesion of ISO class lASTM class
Front cover: Stainless steel 316L#
Glass : Tempered glass. (T=8mm)
Reflector: Optical lens, efficiency>= 90%
Power cable : HO5RN-F2 X 1. 0 mm2L=0. 5M (low voltage/Single color)
Mounting sleeve: 015 PVC
Cable

gland:

1P68            PG-9 PVC
;lass pressure capacity: Full area=2578kgs.
Driver: Constant current output
LED: Multi chip on board LED

Electrical parameters:

Item No. Light source Reflector, Degree(° ) Input voltage(1) Typical
°prating current(mA)
Typical Comsumption(w) Typical luminance(1m) IK rate
EX330 USTSL 1 x 6W COB LED R5 40 24VDC 270 7. Cool white=626 Warm white=458 9

HALCYON LogoHALCYON Logo

Documents / Resources

HALCYON EX330 USTSL LED Inground [pdf] Instruction Manual
EX330 USTSL LED Inground, EX330 USTSL, LED Inground, Inground

References

Leave a comment

Your email address will not be published. Required fields are marked *