Kelly Yana sarrafa UIME-020 ABZ Plus PWM Encoder

Shigarwa

1. Shigar da maganadisu a kan motar motar, tabbatar da cewa an shigar da magnet tare da coaxial da kuma manne tare da shaft (A daya gefen fitarwa).
   Hoto 1: Magnet
   
2. Shigar da mai rikodin ABZ tare da studs, tabbatar da cewa ainihin cibiyar guntu ta tsakiya ta daidaita tare da axis na maganadisu. Tabbatar cewa bambancin axis tsakanin maganadisu da tsakiyar guntu bai wuce 2 mm ba.
   Hoto 2: Encoder
   
   Hoto 3: Shigar da encoder
   
3. Daidaita kaurin iska tsakanin guntu saman saman da maganadisu zuwa tsakanin 1mm da 3mm
   

Takardu / Albarkatu

Kelly Yana sarrafa UIME-020 ABZ Plus PWM Encoder [pdf] Jagoran Shigarwa UIME-020 ABZ Plus PWM Encoder, UIME-020, ABZ Plus PWM Encoder, ƙari PWM Encoder, PWM Encoder

Magana

• Manual mai amfani