• Double-click the mode button on the controller to switch to iOS mode.
• Hold the pairing button for 2 seconds. The indicator light will start scrolling, indicating the pairing process has started.
• On your devices, go to the Bluetooth settings menu. Enable Bluetooth if it’s not already turned on. Tap on “Add New Device” or “Scan for Devices” to search for available Bluetooth devices. Select the “Xbox Wireless Controller” device from the list.
• The interface will display “Connected,” indicating that the pairing process is complete.

Use Method of Auto Pilot Gaming Function

APG function is a recording & repeat playback function for custom commands or macros using the APG button (Double-Square icon button).
Recording process:
Hold the APG button for 3 seconds. You will feel a short vibration, indicating that the recording has started. From this point, all subsequent button presses and joystick movements will be recorded. To stop the recording, either press the APG button again or wait for the recording to automatically stop after 10 minutes. You will feel a long vibration, indicating that the recording is complete. The maximum recording time is 10 minutes. Replay the recorded actions: Press the APG button once briefly to automatically repeat the recorded actions once. Double-click the APG button to continuously repeat the recorded actions until interrupted. During the replay, you can use the joystick for movement, allowing you to perform actions while moving. To cancel the replay midway, press any other button except the joysticks.

DIAGRAM

Back Button Configuration Method

 Back Button Mapping:
Hold the Setting button (Gear icon button) along with the back button you want to map. You will feel a short vibration, indicating that the mapping process has started. Press the desired button that you want to assign to the back button. You will feel a long vibration, indicating that the mapping configuration is complete.

Back Button Mapping Cancellation:
Hold the Setting button (Gear icon button) along with the back button if you want to cancel mapping. You will feel a long vibration, indicating that its mapping is canceled.

• The back buttons can only map to have normal key functions and do not support the Continuous Fire feature.

Trigger Mode Setting Method By toggling the switch on the back

you can easily switch respectively for ZL and ZR triggers between the digital tactile switch trigger mode and Hall effect analog trigger mode. Hall effect analog trigger

• Make sure the triggers are released before switching the triggers mode. Digital microswitch trigger

All special function settings mentioned below require holding down the Setting button @ (Gear icon button) while pressing the corresponding buttons for configuration. All special settings will be automatically saved. When there are special settings configured, the logo light C will be blue. When there are no special settings configured, the logo light c” will be white. During charging, the charging indicator light will be orange, and when fully charged, it will be green. When the battery is low, the logo light G” will flash, and the vibration function will automatically turn off. When the battery level is restored, the vibration will automatically turn back on.

The controller will automatically power off after 10 minutes of inactivity. Alternatively, you can also power off the controller by long-pressing the mode button. However, please note that the controller will not power off automatically when using the full-auto Continuous Fire or replay function (Auto Pilot Gaming). To power on the controller, you can press any of the following buttons: A, B, X, Y, Home, or the mode button.

For more questions & answers, you can visit the website and navigate to the “Support” section and look for the “Frequently Asked Questions” (FAQ) related to the controller.

www.gulikit.com