Guangdong QB077-24TX-05 Remote Control

Product Specifications

• Model: QB077-24TX-05
• Power Settings: 750W, 1500W
• Timer Range: 0-24 hours
• Power: 1500W
• Battery Type: 1.5V AAA (2 pcs)

Product Usage Instructions

• Operation Instructions
  Click the remote control to turn the product on or off. Turning off the product puts it in standby mode.
• Boost Mode:
  Boost mode resets the timer and power settings, ignoring temperature settings. It heats at full power of 1500W for 3 hours and then switches to comfort mode automatically.
• Temperature Adjustment:
  Click to increase or decrease the temperature set point.
• Power Level Adjustment:
  Toggling between 750W and 1500W power levels.
• Countdown Timer:
  Select a countdown time to turn off (0-24 hours). Setting it to 0H cancels the turn off.
• User Precautions
  Ensure the remote control uses 2 pieces of 1.5V AAA batteries installed correctly. If the LED indicator doesn’t light up when pressing a key, check the battery installation. Remove the batteries from the transmitter if not in use for an extended period.

FCC Statement

• Warning:
  Any changes or modifications not approved by the responsible party may void the user’s authority to operate the equipment. Consult the dealer or a radio/TV technician for assistance.
• IC Statement
  This device contains license-exempt transmitter(s)/receiver(s) complying with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). It must not cause interference and should accept any interference that may disrupt its operation.

Operation Instructions

• Click to turn the product on or off. Turn off the product to enter standby mode
• Comfort mode range from 50 to 86 F 10 30 C )), the default value is 86 F 30 C
• ECO mode range from 50 to 86 F 10 30 C )), the default value is 77 F 25 C
• Boost mode will reset the timer and power settings and will disregard the temperature settings. It will heat at full power of 1500 W for 3 hours and will automatically switch to comfort mode after expiration.
• Click to increase the temperature set point
• Click to decrease the temperature set point
• Adjust power level 750W or 1500W
• Select the counts own time to turn off ( 0 24 hour )), 0H cancel turn

User Precautions

• The remote control uses 2 pcs of 1.5V AAA batteries, Please install the batteries correctly. When pressing the key of the transmitter, the LED indicator is not on, Please inspect the battery installation.
• Please pull out of the battery from the transmitter when leaving unused for a long time.

FCC Statement

Warning:
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used according to the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o ff and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

IC Statement
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired o peration of the device.

Frequently Asked Questions

• Q: How do I change the power level on the remote control?
  A: Use the designated buttons on the remote control to toggle between 750W and 1500W power levels.
• Q: Can I leave the batteries in the transmitter for an extended period?
  A: It is recommended to remove the batteries from the transmitter if it will not be used for a long time to prevent any potential damage.

Documents / Resources

Guangdong QB077-24TX-05 Remote Control [pdf] User Manual QB07724TX05, 2BCMJ-QB07724TX05, 2BCMJQB07724TX05, QB077-24TX-05 Remote Control, QB077-24TX-05, Remote Control, Control, Remote

References

• User Manual