Product Specifications
- Model: ETA S 100/200 LED
- Power: Max. 12V=/~ (AC/DC)/1.5A (LED: 12V~/0.02A)
- Operating Voltage: Low voltage only
- Wire Size: Rigid 0.6 – 0.8 mm
Product Usage Instructions
Installation
- Ensure the installation is not in the center, following the provided measurements.
- Mount the push button on the wall bracket securely without a gasket.
- Attach the LED unit firmly in place.
- Optimize the position of wires for proper functioning.
- Secure the gasket on the push button.
- Fixate the screw at the bottom using an Allen key.
Installation
Installation Instructions
- Positions of wire (at the side!)
- Wall fixation of bracket
- Insert wires into gasket
- Connection of push! See 7
- Connect wire (12V~/AC)
- Fix the LED unit
- LED push incl. wiring
- a) Wiring
- b) Unlocking
- Fixation of gasket on push
- Fixation of push on bracket
- Fixation of screw (at bottom)
- Stow opening tool separately because of corrosion possibility!
General
- Please note that installation and assembly of electrical equipment should only be under-taken by a qualified electrician!
- Nationally specific regulations on electrical installation work must be observed
- Before starting installation, ensure that the circuit is isolated from the supply by withdrawing the circuit fuse or circuit breaker!
TECHNICAL DATA
Techn. Dat. Taster/push button
- max. 12 V=/~ (AC/DC) / 1,5A
- Protective low voltage only!
- Wire rigid: 0,6-0,8mm
- Wire flex: unlocking first (1.b)
- -20°C…60°C / IP 44
Techn. Dat. LED
- max. 12V=/~ (AC/DC)/1,5A (LED: 12V~/0,02A)
- Protect. low volt. only!
- Wire rigid: 0,6 – 0,8 mm
- Wire flex: Photo 6.A: Unlock
- -20°C…60°C / IP 54, Druckkraft/Op. force 5 N
Löhestraße 22 * D-53773 Hennef
- Telefon: (0 22 42) 88 90-0
- Telefax: (0 22 42) 88 90-36
- E-mail: info@grothe.de
- Internet: www.grothe.de
FAQ
- Q: What is the maximum power rating for this LED product?
- A: The LED operates at a maximum of 12V=/~ (AC/DC) and 1.5A, with the LED itself consuming 0.02A.
- Q: What type of voltage does this product support?
- A: This product is designed for use with low voltage only.
- Q: What is the recommended wire size for installation?
- A: Use wire sizes ranging from rigid 0.6mm to 0.8mm for proper installation.
Documents / Resources
 |
GROTHE ETA S 100/200 LED Push Button [pdf] Installation Guide 55542, 55544, ETA S 100 200 LED Push Button, 100 200 LED Push Button, LED Push Button, Push Button, Button |