Product Information
The Klingeltaster / Push button Combilux is a device used for doorbell systems. It is designed to be installed in a deenergized condition by a qualified electrician. The product allows for the connection of multiple push buttons and offers the option of an LED indicator.
Technical Specifications
- Model: MV 510150
- Date: 02/23
- Input Voltage: 8-12V~
- Transformer Type: SELV (Safety Extra Low Voltage) – Complies with Norm EN61558-2-6/-2-8
Product Usage Instructions
- Ensure that the installation is carried out by a qualified electrician in a deenergized condition.
- Use the provided screws to fix the device to the wall, maintaining a distance of 32mm between the screws.
- Connect the necessary wires according to the wiring diagram.
- If using multiple push buttons, remove two ribs in the base of the device to allow for their attachment.
- If desired, install the LED indicator by following the LED option instructions.
- For each push button, connect the corresponding wires to the “L” and “C0” terminals.
- If using the LED option, connect the necessary wires according to the LED transformer instructions.
- The input voltage for the device should be between 8-12V~.
Installation
Installation must be carried out in deenergized condition by an electricial!
- Open the casing
- Wall fixation (Dist. 32mm)
- Strip the wires (6mm)
- Connect wires
- Insert name plate, close cover
- Combinat. several pushes
- Remove 2 ribs in the base
- Connect wires etc.
WIRING DIAGRAM
Technical data
- 8 – 12 V ~ (AC 5 mA – 1,5 A)
- 8 -12 V = (DC 5 mA – 1,0 A)
- LED: 8 – 12 V~ (AC 0,02 A)
- Protect. low volt. only!
- Leiter/Wire 0,6 – 0,8 mm
- 20°C…60°C
- [P41
- Op. force ca. 6 N
ABOUT COMPANY
- Grothe GmbH
- 53773 Hennef
- Löhestraße 22
- service@grothe.de
Documents / Resources
 |
GROTHE 51015 Push Button Combilux [pdf] Instruction Manual 51015 Push Button Combilux, 51015, Push Button Combilux, Button Combilux, Combilux |
