GME PL259 Plug Fitting Instructions

GME PL259 Plug Fitting

Installation Instruction

1. Remove collar from plug and slide over cable (ensure correct position).
   
2. Cut away black outer layer of cable. Cut a small black section (approx. 2 mm) off the end and put aside for later (step 5).
   
3. Peel back braid.
   
4. Cut away white section, leaving approx. 3 mm.
   
5. Fit small black section (step 2) over the white.
   
6. Screw plug over exposed cable.
   
7. Trim off excess braid. Trim off excess and solder-exposed wire to pin.
   
8. Bring back collar and screw over plug.
   

Customer Support

gme.net.au

GME Pty Ltd
Part Number: 310069 Drawing Number: 54110-1