SK2-RX One Wire Keypad Reader
User Manual
Introduction
The device is a 1-Wire output keypad, with an integrated proximity reader. It can read 125KHz EM & HID Card and 13.56MHz Mifare Card. The enclosure of the keypad is made of thicke ned ABS, strong and durable; the keys are made of abrasion-proof euphotic silicone, convenient to use at night. Because of waterproof, it can be mounted either indoors or outdoor in harsh environments.
Features
Waterproof conforms to IP66
Standard 1-Wire output
Card Type: HID Card, EM Card & Mifare Card
Reading range: 0~6cm
Specification
| Frequency | 125KHz & 13.56MHz |
| Card Type | 125KHz – EM & HID Cards/Fobs 13.56MHz – Mifare Cards/Fobs |
| Read Range | 0-6 cm |
| Standby Current | .n5mA |
| Operating Voltage | 9-80V DC |
| Operating Temperature | -40t-60t |
| Operating Humidity | 0% RH – 95% RH |
| Color | Black |
| Index of Protection | IP66 |
| Dimension | L122 x W50 x D21 mm |
| Net Weight | 155g |
| Shipment Weight | 210g |
Installation
- Drill 2 holes (A, C) on the wall for the screws and one hole (B) for the cable
- Knock the rubber bungs into the holes (A, C)
- Fix the back cover on the wall with 2 screws
- Thread the cable through the cable hole (B)
- Attach the unit to the back cover
Wiring:
| Color | Function | Notes |
| Red | Power+ | 9 — 80V DC Power Input |
| Black | GND | Ground |
| Green | Data | 1-Wire Data Output |
| Yellow | Feedback | Feedback Input |
Packing list
| No. | Name | Quantity |
| 1 | Box | 1 |
| 2 | Reader SK2-RX | 1 |
| 3 | Wall Fixing Plugs | 2 |
| 4 | Self Tapping Screws | 2 |
| 5 | Screw Driver | 1 |
FCC Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Documents / Resources
 |
Gem One SK2-RX One Wire Keypad Reader [pdf] User Manual GEM-ACC-KP, GEMACCKP, 2AYCQGEM-ACC-KP, 2AYCQGEMACCKP, SK2-RX One Wire Keypad Reader, SK2-RX, One Wire Keypad Reader |
