FUNPOWER FT12W10YG Remote Control Transmitter
USER MANUAL
I. Operation Instructions
1. LED Indicator
2. Fan OFF
3. Fan Speed 1~6
4. Fan Forward/Reverse @Light Control
5. Power switch
II. Use precautions
1. When press the key of transmitter, the LED indicator doesn’t on, please check whether the power switch is on.
2. Please disconnect power switch when leaving unused for a long time.
FCC Instructions:
This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This product generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If the product does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the product and receiver.
- Connect the product into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference an,d
(2) this device must accept any interference received, including interference that may cause Undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the product.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
FCC ID:2ABUP-FT12W1 OYG
IC Caution:
RSS-Gen Issue 5 “&” RSS-Gen numero 5
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
RF exposure statement:
The equipment complies with IC Radiation exposure limit set forth for uncontrolled environment.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Documents / Resources
 |
FUNPOWER FT12W10YG Remote Control Transmitter [pdf] User Manual FT12W10YGA, FT12W10YGB, FT12W10YG Remote Control Transmitter, FT12W10YG, Remote Control Transmitter, Control Transmitter, Transmitter |
