USER MANUAL for FT12W10YGA Remote Control Transmitter

I. Operation Instructions

The remote control features a rectangular black casing with several buttons. A circular arrangement of numbered buttons (1-6) is prominent, along with a 'CCT' button and a power switch at the bottom. An LED indicator is present near the top.

The functions of the buttons are as follows:

• ① LED Indicator: Indicates the status of the remote.
• ② Fan OFF: Turns the fan off.
• ③ Fan Speed 1~6: Controls the fan speed from 1 to 6.
• ④ Fan Forward/Reverse: Changes the fan's rotation direction.
• ⑤ Light Control: Controls the connected light.
• ⑥ Power switch: The main power switch for the remote.

II. Use Precautions

• When the transmitter key is pressed and the LED indicator does not illuminate, please check if the power switch is on.
• Please disconnect the power switch when leaving the device unused for an extended period.

FCC Instructions

This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This product generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If the product does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the product and receiver.
• Connect the product into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

• This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
• (1) This device may not cause harmful interference.
• (2) This device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the product.

The device has been evaluated to meet general RF exposure requirements and can be used in portable exposure conditions without restriction.

FCC ID: 2ABUP-FT12W10YG

IC Caution

RSS-Gen Issue 5 & RSS-Gen numéro 5

English:

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions:

• (1) This device may not cause interference.
• (2) This device must accept any interference, including interference that may cause undesired operation of the device.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

RF exposure statement: The equipment complies with IC Radiation exposure limits set forth for uncontrolled environments. The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.