Fuallwin FW920 Ai Intelligent Voice Recorder Instruction Manual

FW920 Ai Intelligent Voice Recorder

Product Information

Specifications:

  • Model number of products: AI intelligent voice recorder
  • Cell and combination method: Polymer battery/400mAh/1
    piece
  • Input input interface: Magnetic suction contact
  • Storage of machine: 32GB/64GB
  • Whether the recording is encrypted: No
  • Recording support format: MP3
  • Recording bit rate: 32kbps
  • Length of recording: Up to 35 hours
  • Mode of recording: Start recording on the machine/start
    recording on the APP
  • Power off standby time: About 166 days
  • Microphone performance: Simulated silicon wheat + bone wheat
    5.0
  • Bluetooth protocol: 5.0
  • Transport protocol: USB 1.0/2.0
  • Whole machine material: Aluminum alloy
  • Operating service temperature: 0 to 45 degrees Celsius

Product Usage Instructions:

Power On/Off:

Power off status: Press and hold the power button for 3 seconds
to shut down the device.

Power on status: Press and hold the power button for 3 seconds
to turn on the device.

Screen Activation:

Standby status: When the screen is off, short press the power
button to activate the screen.

Recording Functions:

To start recording: Push the recording button up, and the
recorder will vibrate once to indicate that recording has
started.

To pause recording: Short press the power button while recording
to pause.

To end recording: Push the recording button down, the recorder
will vibrate twice, and “Save” will appear on the display,
indicating that the recording has been saved and ended.

Mode Switching:

CALL Mode (Call recording mode): Double-click to switch to Call
mode when the display is on.

NOTE Mode (Regular recording mode): Double-click to switch to
Note mode when the display is on.

Bluetooth Connection:

To connect via Bluetooth: Open the app, search for product
equipment, and connect to Bluetooth.

Frequently Asked Questions (FAQ):

Q: Is the recording encrypted?

A: No, the recording is not encrypted.

Q: What is the length of recording supported?

A: The device supports recordings of up to 35 hours.

Q: What is the standby time when the device is powered
off?

A: The power off standby time is about 166 days.

“`

Instruction manual
To ensure the best use experience, please read the user manual carefully and keep this
manual properly for future reference

Operation and function description
1 23

4

5

6

1 Display 2 Power key 3 Record button

4 Mic hole 5 Mic hole 6 Magnetic interface

Operation instruction

Power off status Press and hold Power on status Press and hold

the power button for 3 seconds the power button for 3 seconds

to turn on the device.

to shut down the device.

3S

3S

Welcome

See you

Standby status
When the screen is light off, short press the power button to light the screen.
NOTE

Start recording

Push the recording button up and the recorder vibrates once, Indicating that recording has started.

Start recording

NOTE

x1

Pause recording
Short press the power button topause while recording. Pause in recording
NOTE

End recording
Push the recording button down, the recorder vibrates twice, and the word “save” appears on the display, which means saving and ending the recording.

Save

End recording

x2

Save

CALL Mode (Call recording mode) Double-click to switch to Call mode when the display s light on.

NOTE Mode (Regular recording mode)Double -click to switch to Note mode when the display is light on.

NOTE

NOTE

Bluetooth connect
Open APP search product equipment and connect to bluetooth.
Conrected

Connecting devices

Bluetooth not connected
NOTE

Bluetocth connected
NOTE

Product Information

Model number of products Cell and combination method Input input interface
Storage of machine Whether the recording is encrypted Recording support format
Recording bit rate
Length of recording
Mode of recording
Power off standby time
Microphone performance
Bluetooth protocol
Transport protocol
Whole machine material Operating service temperature

AI intelligent voice recorder Polymer battery /400mAh/1 piece Magnetic suction contact
32GB/64GB
no
MP3
32kbps
Up to 35 hours Start recording on the machine/ start recording on the APP About 166 days Simulated silicon wheat + bone wheat 5.0
USB 1.0/2.0
Aluminum alloy
0 to 45 degrees Celsius

Matters needing attention
Legal restrictions
Please strictly abide by relevant laws and do not use this product illegally. The company does not assume any commitment or responsibility for the consequences of Illegal behavior.
Privacy Protection All data is stored only on the recording device, unless you sync the recording file with the app. In this case, the file will be stored on the smartphone.
Data Security The company is not responsible for loss or damage of personal data caused by hardware, software, product maintenance, battery replacement or other unexpected circumstances.
Product setting Due to firmware upgrades, the actual settings and usage of this product may be different from this manual. If product performance and functions change, pleaserefer to the latest product.
Security Keep the device and accessorles out of the reach of children to avoid choking or other injuries.Do not expose the battery (battery pack or installed batteries) to fire or excessive heat (such as sunlight, etc.)
Important Notice Do not use chemicals or reagents to clean the recorder, as this will damage the surface of the recorder and corrode it.

Battery If the product is not used for a long time, please charge and discharge the product once every three months to prevent battery damage.
Memory storage capacity The system software estimates a small amount of storage space. Actual available capacity will be slightly less than what is shown in the specifications.
The Management of Low-Power Radio Frequency Radiation Motors
For low-power radio frequency equipment that has obtained a password certificate, companies, businesses or users are not allowed to change the frequency, increase the power or change the original design characteristics and functions without approval. The use of low-power radio frequency equipment shall not affect flight safety and interfere with legal communications: if interference is found, it should be immediately stopped and can only be used again after improvement to no interference. The legal communication in the preceding paragraph refers to radio communications operating in accordance with the provisions of the Telecommunications Management Act. Low-power radio frequency equipment must withstand interference from legal communications or industrial, scientific and medical radio wave radiating electrical equipment.
Radio frequency exposure This device has been evaluated to complywith the general RF exposure requirements. This device may be used without restriction in portable exposure conditions.

Please search “DOWAY “in the corresponding mobile system APP store to download the APP, or scan the QR code below to jump to the app store to download
the app.

FCC Warnning: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipment generates, uses and can radiateradio frequency energy and, if not installed and used in accordance with the instructions, maycause harmful interference to radio communications. However, there is no guarantee thatinterference will not occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipmentoff and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0cm between the radiator and your body.

Documents / Resources

Fuallwin FW920 Ai Intelligent Voice Recorder [pdf] Instruction Manual
FW920, FW920 Ai Intelligent Voice Recorder, Ai Intelligent Voice Recorder, Intelligent Voice Recorder, Voice Recorder, Recorder

References

Leave a comment

Your email address will not be published. Required fields are marked *