FTI-NSP3: Vehicle Coverage and Preparation Notes

• Install Type 2 requires BLADE-AL(DL)-NI3 firmware, flash module and update the controller firmware before installing.
• CAN: The NSP3 harness does not require any additional connections or special configuration of the harness for CAN data connections, the NI3 CAN connections are hardwired between the black 20-pin BLADE and black 40-pin BCM connectors.
• Lights: Visual status confirmations and diagnostic information are provided via hazard lights when using the NSP3 harness.
• The controller POC1 output must be configured for one of the following settings (depending on switch type):
• Hazard light [ 30 ] (momentary hazard switch)
• Hazard light 2 [ 23 ] (latching hazard switch)

POC Configuration:

• CMX: POC2 – 2nd START [ 2 ]
• POC3 – 2nd IGN [ 3 ]
• CM9: POC3 – (-) START
• POC4 – (-) IGNITION

I/O Changes: Type 2 requires configuring the CN1 blue wire for ACC output, controller specific settings are listed.
Vehicle Damage Warning:
Caution should be taken to avoid mixing up the BCM connectors, vehicle damage will result if the connectors are positioned improperly. It is advised that you make the BCM connections one at a time, confirming that each T-harness connection is at the correct BCM position before proceeding to the next connection, attempting to program, or attempting to remote start.

FTI-NSP3: Installation and Configuration Notes

• A REQUIRED CONNECTIONS – SECURE UNUSED I/O CONNECTORS
• B REQUIRED CONNECTIONS – SEE WARNING ABOVE
• C REQUIRED CONNECTION

FTI-NSP3 – DL-NI3 – Type 2 2020-24 Nissan Frontier Intelli-Key PTS AT

LED Programming Error Codes
Module LED flashing RED during programming

• 1x – No CAN activity, check connectors, check CAN voltages
• 2x – No immobilizer data, confirm connectors used
• 3x – VIN detection error, contact support
• 4x – No ignition, confirm connection and voltage

CARTRIDGE INSTALLATION

1. Slide cartridge into unit. Notice button under LED.
2. Ready for Module Programming Procedure.

MODULE PROGRAMMING PROCEDURE

1. Push start button twice [2x] to ON position.
2. Wait, LED will turn solid BLUE for 2 seconds
3. Push start button once [1x] to OFF position.
4. Module Programming Procedure completed.

PUSH TO START VEHICLE TAKE OVER PROCEDURE – TO THE VEHICLE OWNER

NOTE
This procedure is to be followed during remote starter runtime prior to entering vehicle.
All vehicle doors must be closed.

1. Press UNLOCK on after-market remote or OEM fob.
2. Open vehicle door.
   Enter vehicle WITH THE OEM FOB.
   Close vehicle door.
3. Wait for the LED indicator of the push button to be in the ON position.
   OR
   Wait for the ORANGE LED indicator of the push button to turn on.
4. Press and release BRAKE pedal.
5. It is safe to select gear ONLY AFTER LED indicator is in ON position.
6. Push to Start vehicle take over procedure completed.

Failure to follow procedure may result in vehicle displaying CHECK ENGINE or TIRE PRESSURE error messages.

 © 2020 Automotive Data Solutions Inc.
WWW.IDATALINK.COM

Documents / Resources

FIRSTECH FTI-NSP3 Frontier Intelli Key PTS AT [pdf] Installation Guide FTI-NSP3 Frontier Intelli Key PTS AT, FTI-NSP3, Frontier Intelli Key PTS AT, Intelli Key PTS AT, Key PTS AT, PTS AT, AT

References

• User Manual