FERNOX-LOGO

FERNOX TF1 Omega Filter

FERNOX-TF1-Omega-Filter-PRO

INTRODUCTION

Designed for installation in small or restricted access areas, this high-performance, easy to clean system filter uses Hydronic Particle Separation and magnetic filtration to remove contaminants from central heating system water.

  • High capacity and compact design
  • Ideal for use in restricted spaces and access areas
  • Easy to install – fits on horizontal and vertical pipework in both flow directions. The filter can operate at an angle of 45°
  • Fast and easy to clean without dismantling the unit
  • Unique action, removes magnetic and non-magnetic contaminants from system water
  • High quality valves are included
  • Will not block or restrict flow
  • Smart, tough, forged brass construction (no hidden porosity) with nickel plating
  • Unique manifold with double radial seals and multiple orientation capability
  • Powerful neodymium magnet assembly with threaded magnet cap
  • As with all magnetic products, if you have an implanted cardiac device extra caution should be taken at all times when handling any magnetic filter
  • Available as 22mm and 28mm products

Product Specifications

  • Maximum operating temperature: 100°C
  • Maximum operating pressure: 10 bar
  • Maximum flow rate: 50 L/min
  • Magnetic characteristics: Powerful neodymium magnetic assembly
  • Drain valve characteristics: Easy to install with multiple orientation capability
  • Filter material: Tough, forged brass construction with nickel plating. Compatible with EN 12165-CW617N-M

Weight

  • TF1 Omega Filter 22mm 2400g (with magnet and drain valve)
  • TF1 Omega Filter 28mm 2642g (with magnet and drain valve)

DIMENSION

TF1 Omega Filter 22mm

FERNOX-TF1-Omega-Filter- 10

TF1 Omega Filter 28mm

FERNOX-TF1-Omega-Filter- 11

Cleaning Guide

  1. Switch off the boiler.FERNOX-TF1-Omega-Filter- (2)
  2. Close the inlet/ outlet valves. Remove the drain valve cap.FERNOX-TF1-Omega-Filter- (3)
  3. Open the drain valve.FERNOX-TF1-Omega-Filter- (4)
  4. Remove the magnet. Slowly open the inlet valve to control the flow. Flush out the filter until the water runs clear.FERNOX-TF1-Omega-Filter- (5)
  5. Close the inlet valve. Close the drain valve.FERNOX-TF1-Omega-Filter- (6)
  6. Replace the drain valve cap. Reinsert the magnet.FERNOX-TF1-Omega-Filter- (7)
  7. Open the inlet/ outlet valves.FERNOX-TF1-Omega-Filter- (8)
  8. Restart the boiler.FERNOX-TF1-Omega-Filter- (9)

www.fernox.com

Documents / Resources

FERNOX TF1 Omega Filter [pdf] Instructions
TF1 Omega Filter, TF1, Omega Filter, Filter

References

Leave a comment

Your email address will not be published. Required fields are marked *