PULSE Series One App
Product Information
Specifications:
- FCC ID: 2BQSO-WS01X
- Model: PULSE
- RF Exposure: Compliant with general RF exposure
requirements - Usage: Portable exposure condition without restriction
Product Usage Instructions:
- Ensure the device is fully charged before initial use.
- Power on the device by pressing and holding the designated
power button. - Follow the on-screen prompts for initial setup and
configuration. - To start using the device, navigate through the menu options
using the provided controls. - Refer to the user manual for specific functionalities and
features of the device. - Properly maintain and clean the device as per the care
guidelines provided. - If you encounter any issues, refer to the troubleshooting
section of the user manual or visit the support website for
assistance.
Frequently Asked Questions (FAQ):
Q: Is the PULSE device waterproof?
A: No, the PULSE device is not waterproof. Avoid exposing it to
water or moisture to prevent damage.
Q: How do I charge the device?
A: Use the provided charging cable to connect the device to a
power source. Follow the charging guidelines mentioned in the user
manual.
Q: Can the device be used while charging?
A: Yes, you can use the device while it is charging. However,
ensure that the charging cable does not interfere with the device’s
operation.
Q: What should I do if the device freezes?
A: In case of a device freeze, try restarting it by performing a
soft reset. If the issue persists, contact customer support for
further assistance.
FCC ID 2BQSO-WS01X
QUICK CARE GUDE
PULSE
FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: – Reorient or relocate the receiving antenna. – Increase the separation between the equipment and receiver. – Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. – Consult the dealer or an experienced radio/ TV technician for help.
FCC RF exposure statement: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
For mor e det al ed i nf or mat i on, pl ease vi si t pl use. si t e/ suppor t
Documents / Resources
 |
FASTMIND LABS PULSE Series One App [pdf] User Guide WS01X, 2BQSO-WS01X, 2BQSOWS01X, PULSE Series One App, Series One App, One App, App |