FAGERHULT ML Hydro G3 Surface Mounted
Product Specifications
- Model: ML Hydro G3 surface mounted
- Dimensions: 1050mm x 200mm x 200mm
- Available Sizes: 300×600, 450×200, 600×600, 450×450, 300×1200
- Cable Management: Cable through top for both variants; cable through short side only for glass variant
- Mounting: Glass/Robust; Kardborre/Velcro
Installation Instructions
- Press the frame against the body.
- Cross-tighten screws with the right torque.
- Use T20 screwdriver, Max 3Nm torque.
Safety and Compliance
- Notice: Management regulations against electrostatic discharge must be observed.
- Insulation: Basic insulation is required between mains and control wiring.
- Replacement: The light source and control gear should only be replaced by the manufacturer or its designated person.
Basic insulation between mains and control wiring.
Manufacturer Information
Manufactured by Fagerhult Sweden.
For UK market importer: Fagerhult UK, 33-34 Dolben Street, London, SE1 OUQ.
Additional Information
It is appropriate that this information is passed on to the users of the installation.
Frequently Asked Questions
- Q: Can the light source be replaced by the user?
A: No, the light source and control gear should only be replaced by the manufacturer or its designated person for safety reasons. - Q: What is the recommended torque for tightening the screws during installation?
A: Use a T20 Torque Wrench with a maximum torque of 3Nm to cross-tighten the screws securely.
Documents / Resources
 |
FAGERHULT ML Hydro G3 Surface Mounted [pdf] Instruction Manual Surface mounted, ML Hydro G3 Surface Mounted, ML Hydro G3, Surface Mounted, Mounted |