FABER WIREBOX2 Wiring Box Kit
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
- Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction.
- When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
CAUTION: To reduce The Risk Of Fire and Electric Shock, this Rangehood Wiring Box Kit shall be used only with Faber Rangehood Models that have been investi-gated and found acceptable for use with this Kit. See hood manual to determine compatibility.
PARTS
PARTS INCLUDED
| REF. | PART | QTY | |
| H | Pozi Screws (2/16″ x 6/16″) |  |
2 |
| G | Pozi Screws (3/16″ x 1/8″) |  |
2 |
|
I |
Cover |  |
1 |
NOTE: this is only used with the Breva hood products.
MAIN PARTS
- Disconnect the power cable from the control box.
- Remove the power cable from the hood and away from the strain relief. Place the strain relief back into the hole.
- Attach the Wiring Box to the hood with 2 screws (G) in rear or top position.
Rear position:
Top position:
- Connect the Power Supply Cable to the rangehood. Attach the White lead of the power supply to the White lead of the rangehood with a twist-on type wire connector. Attach the Black lead of the power supply to the Black lead of the rangehood with a twist-on type wire connector. Connect the Green (Green and Yellow) ground wire under the Free Green grounding screw.
- Close the Power Supply box with 2 screws (H).
- Connect the Power Supply Cable to the rangehood.
Documents / Resources
 |
FABER WIREBOX2 Wiring Box Kit [pdf] Instruction Manual WIREBOX2 Wiring Box Kit, WIREBOX2, Wiring Box Kit, Wiring Box |
