Extreme Terrain JEE0718-NLC Control Arm Bracket
BEFORE INSTALLATION
- All modifications must be installed by qualified personnel. You confirm that you fully understand the risks that may arise from the use of this product,and voluntarily assume all consequences and legal responsibilities arising from the use of this product. You should ensure that the vehicle after installing this product complies with relevant national and local laws and regulations, and limit the use of this product to specific scenarios permitted by laws and regulations.
- Prepare OE Service Manual for the model /year of the vehicle. Refer to the manual for proper disassembly/reassembly procedures of OE and related components.
- Adapt to vehicles that are raised at least 2″-4″ in height.
IT KIT CONTENTS
INSTRUCTION
- Use a jack to lift the vehicle, ensuring there is enough working space.
- Remove the front upper and lower control arms.
- Take out the brackets and position them at the original connection points between the lower control arm and the vehicle frame, aligning the holes as shown in the diagram. Secure the brackets to the frame using bolts and nuts.
- Connect the bushing end of the upper and lower control arm to the frame. Do not connect the ball joints to the steering joints yet.
- Attach the upper and lower control arms to the brackets and the vehicle body, as shown in the diagram.
- Repeat steps 2-5 on the other side.
- Tighten all nuts, restore the factory torque specifications, and perform a final inspection.
AFTER INSTALLATION
An Alignment Is Highly Recommended After Installation
Highly suggest drivers inspect the nuts and bolts for tightness regularly.
WARNING
Cancer and Reproductive Harm
www.P65Warnings.ca.gov
Documents / Resources
 |
Extreme Terrain JEE0718-NLC Control Arm Bracket [pdf] Installation Guide JEE0718-NLC, JEE0718-NLC Control Arm Bracket, Control Arm Bracket, Arm Bracket, Bracket |