830 SERIES
Troffer Installation Guide
830 Series Troffer
WARNING
- To avoid electric shock, disconnect power at source prior to installation.
- The installation should be performed by qualified electricians or lighting technicians.
- Before conducting any installation, maintenance, or removal, disable all power.
- Do not touch the fixture while it is in service.
- If there is any problem with the fixture, turn off power and DO NOT attempt repair unless you are a qualified technician or the customer service member.
Recessed Installation
| 1 |  |
Insert fixture into ceiling grid. |
| 2 |  |
Bend out mounting tabs 90degrees on each corner. |
| 3 |  |
Use hanger wire to tie off appropriately in accordance with local building codes. |
| 4 |  |
Install conduit containing the conductors to the knockout of the cover plate and make all electrical connections to the fixture. Attach cover plate. |
Surface Mount Installation
| 1 |  |
Assemble three sides of the bracket with the included screws. |
| 2 |  |
With the open side facing the junction box, ensure the frame is square, then secure with appropriate fasteners. |
| 3 |  |
Pull the conduit hose towards the open side, then insert luminaire partially into the mounting bracket. Make all electrical connections as shown in Wiring Diagram 2. |
| 4 |  |
Push the conduit hose back into the surface mount frame and fully insert the luminaire. When installed properly the luminaire will rest on the flanges of the frame. |
| 5 |  |
Slide the final side of the frame into the slots, ensuring that it locks into place. Secure with the included screws. |
| 6 |  |
Installation is complete. Your fixture is ready to power on. |
Wiring Diagram 1
Wiring Diagram 2
Field Adjustable Wattage and CCT
- Kelvin and wattage can be adjusted using the dip switches located on the driver.
- Select the desired kelvin and wattage by sliding the appropriate dip switch.
Copyright © 2022 ESL Vision, LLC. All rights reserved. Rev: 07/19/22
888.493.5559
info@eslvision.com
www.eslvision.com
Documents / Resources
 |
ESL VISION 830 Series Troffer [pdf] Installation Guide 830 Series Troffer, 830 Series, Troffer |
