Installation Guide for ESL VISION models including: 830 Series Troffer, 830 Series, Troffer
860 SELECTABLE STRIP RETROFIT • 8' •
Resources – Installation Guides •
ESL Lighting – Green Electrical Supply
830 SERIES Troffer Installation Guide Page 1 of 2 WARNING 1. To avoid electric shock, disconnect power at source prior to installation. 2. The installation should be performed by qualified electricians or lighting technicians. 3. Before conducting any installation, maintenance, or removal, disable all power. 4. Do not touch the fixture while it is in service. 5. If there is any problem with the fixture, turn off power and DO NOT attempt repair unless you are a qualified technician or the customer service member. Recessed Installation 1Insert fixture into ceiling grid. 2Bend out mounting tabs 90 degrees on each corner. Surface Mount Installation 3Use hanger wire to tie off appropriately in accordance with local building codes. 4Install conduit containing the conductors to the knockout of the cover plate and make all electrical connections to the fixture. Attach cover plate. 1 Assemble three sides of the bracket with the included screws. 2 With the open side facing the junction box, ensure the frame is square, then secure with appropriate fasteners. 3 Pull the conduit hose towards the open side, then insert luminaire partially into the mounting bracket. Make all electrical connections as shown in Wiring Diagram 2. 4 Push the conduit hose back into the surface mount frame and fully insert the luminaire. When installed properly the luminaire will rest on the flanges of the frame. 5 Slide the final side of the frame into the slots, ensuring that it locks into place. Secure with the included screws. 6 Installation is complete. Your fixture is ready to power on. Copyright © 2022 ESL Vision, LLC. All rights reserved. Rev: 07/19/22 830 SERIES Troffer Installation Guide Wiring Diagram 1 120277V Black (Line) White (Neutral) Green (Gnd) Dimming wire to 010V IEC compliant control Lead Wire to LED Load Purple Pink (Dim + ) (Dim - ) Blue ( - ) Red ( + ) Field Adjustable Wattage and CCT 1Kelvin and wattage can be adjusted using the dip switches located on the driver. 3500K 5000K 2Select the desired kelvin and wattage by sliding the appropriate dip switch. CCT Switch Wiring Diagram 2 Gnd ACL ACN Dim + Dim LED + LED LED Driver Page 2 of 2 AC Line Green Black White To 010V Dimmer Wattage Switch Copyright © 2022 ESL Vision, LLC. All rights reserved. Rev: 07/19/22Adobe PDF Library 16.0.7 Adobe InDesign 17.3 (Macintosh)