EPS CSCSPR10-16D4 Changeover Switch
Specifications
- Type: Changeover Switch (CSCSP)
- Stable Positions: 3 (O, 1, 2)
- Type of Installation:
- Parallel and level installation
- Rear / Din Rail installation
- Surface installation
- Rated Continuous Current:
- 10, 16, 20, 25, 32, 40, 63, 80, 100A
Introduction
Changeover Switch
By means of manual operation, Changeover Switch (CSCSP) performs circuit switching and is mainly used as a switching device of two independent circuits – I & II. It provides three stable positions.
- Position Operation
- 0 Load is open-circuited
- 1 Load is connected to the normal supply
- 2 Load is connected to the second source of supply
Parallel & Level installation
Type of Installation
- Parallel and level installation
- Rear / Din Rail installation
- Surface installation
IEC/EN 60947
Changeover Switches
Open execution Changeover Switches – CSCSPR 10 ~ 100A (Rear / Din Rail Installation)
| Circuit Diagram | Rated continuous current Iu A |
Reference |
Pole no.of main contact | Rated power of 3 ph. motor 50~60Hz |
| KW at 415V (AC23A) |
Main switch without auxiliary contact
Open execution Changeover Switches – CSCSPR 10 ~ 100A (Rear / Din Rail Installation)
CSCSPR10/16/20/25/32/40D3/
Note: All dimensions are in mm.
FAQ
- Q: What are the stable positions of the Changeover Switch?
- A: The Changeover Switch provides three stable positions: O (load open circuited), 1 (load connected to normal supply), and 2 (load connected to the second source of supply).
- Q: What type of circuits can the Changeover Switch be used for?
- A: The Changeover Switch is mainly used as a switching device for two independent circuits – I & II.
Documents / Resources
 |
EPS CSCSPR10-16D4 Changeover Switch [pdf] Instruction Manual CSCSPR10-16D4, CSCSPR20D4, CSCSPR25D4, CSCSPR32D4, CSCSPR40D4, CSCSPR63D4, CSCSPR80D4, CSCSPR100D4, CSCSPR10-16D4 Changeover Switch, CSCSPR10-16D4, Changeover Switch, Switch |