EPH CONTROLS R17V2 1 Zone RF Time Switch Pack
Setting the date & time
- Lower the cover on the front of the unit.
- Press
, ‘P01 tInE’ will appear on the screen. - Press
, the year will begin to flash. - Press
and
to adjust the year. Press. - Repeat the above to select the MONTH, DAY, HOUR, and MINUTE.
- When this is complete Press and the time switch will return to normal operation
ON/OFF settings
4 different settings available
How to select
- Lower the cover on the front of the unit.
- By pressing the button to change between settings for the times
- Lower the cover on the front of the unit.
- By pressing the button
to change between settings for the times
Factory program settings
Adjusting the program settings
- Press the
Button. - Press the or buttons to adjust the P1 ON time. Press .
- Press the or buttons to adjust the P1 OFF time. Press .
- Repeat this process to adjust the ON & OFF times for P2 & P3.
- When this is complete Press and the timeswitch will return to normal operation.
Boost function
This function allows the user to turn ON the timeswitch for a period of 30mins, 1, 2, or 3 hours. This does not affect your program settings. If the zone that you wish to Boost is timed to be OFF, you have the facility to switch it ON for 30 minutes, 1, 2 or 3 hours.
- Press the
button once, twice, three or four times respectively. - To cancel the boost function, simply press the button again.
Operating the thermostat
The thermostat will allow the timeswitch to activate provided the ambient temperature is below the setpoint.
- Adjusting the temperature setpoint: Rotate the dial
clockwise to increase or decrease the temperature setpoint counterclockwise. You can press the dial to confirm or the temperature will be controlled automatically after 5 seconds. - Boost from the thermostat You can activate the timeclock for 30mins, 1, 2 or 3 hours by pressing
the button on the thermostat 1, 2, 3 or 4 times. The thermostat will display bSt 00:30, 01:00, 02:00, 03:00 to represent what is selected. To cancel the boost function, simply press the button again.
Important: Keep this document
Introduction to your R17V2 Timeswitch
- The R17V2 timeswitch has up to three daily heating programs called P1, P2 and P3. When in the AUTO mode, it will show when the timeswitch is next programmed to be switched ON or OFF. When the timeswitch is ON, the red LED lights up. This indicates that power is being sent from the timeswitch.
contact
Documents / Resources
 |
EPH CONTROLS R17V2 1 Zone RF Time Switch Pack [pdf] Instructions R17V2, R17V2 1 Zone RF Time Switch Pack, 1 Zone RF Time Switch Pack, RF Time Switch Pack, Switch Pack, Pack |
