CDTP2CDTP2 Room Thermostat Hardwired
Instruction Manual
Important: Keep this document 
CDTP2 Room Thermostat Hardwired
Installation Instructions
For use in normal environments.
CDTP2CDTP2 Room Thermostat Hardwired
CAUTION! Installation and connection should only be carried out by a qualified person and in accordance with national wiring regulations.
- Before commencing any work on the electrical connections, you must first disconnect the thermostat from the mains.
- None of the 230V connections must be live until the installation has been completed and the housing is closed.
- Only qualified electricians or authorised service staff are permitted to open the thermostat.
- There are parts that carry mains voltage behind the cover. The thermostat must not be left unsupervised when open. (Prevent non specialists and especially children from gaining access to it.)
- If the thermostat is used in a way not specified by the manufacturer, its safety may be impaired.
- Prior to setting the thermostat, it is neccessary to complete all required settings described in the section.
This thermostat can be mounted in the following ways:
- To a recessed conduit box
- To a surface mounted box
- Directly mounted on wall
EPH Controls Ireland
technical@ephcontrols.com
www.ephcontrols.com
EPH Controls UK
technical@ephcontrols.co.uk
www.ephcontrols.co.uk
Documents / Resources
 |
EPH CONTROLS CDTP2CDTP2 Room Thermostat Hardwired [pdf] Instruction Manual CDTP2CDTP2 Room Thermostat Hardwired, CDTP2CDTP2, Room Thermostat Hardwired, Thermostat Hardwired |
