Hilti HAC-C-T Anchor Channel Installation

Product Compliance and Manufacturer Information

CE Mark: 24

Manufacturer: Hilti AG

Address: LI-9494 Schaan, Hilti Werke

CPR Certification: 0672-CPR-1081

ETA Certification: ETA-17/0336

Notified Body: 0672

EAD Reference: EAD330008-04-0601

Product Description: Anchor channels for fixing to concrete.

Manufacturer Website: www.hilti.group

Installation Instructions

Step 1: Positioning and Visual Check

Place the anchor channel with pre-installed anchors. Perform a visual check ⚠️.

Step 2: Securing and Model Selection

Secure the anchor channel. Observe safety guidelines: wear safety glasses ?, wear gloves ?, wear ear protection ?. Ensure correct installation ✔️. Do not use hammer ??.

Step 3: Prohibited Actions

Prohibited actions include cutting ?✂️, bending ??, and other modifications ??.

Step 4a: Cutting the Anchor Channel

Cut the anchor channel using a saw. Ensure a minimum of 2 cuts (min. 2x).

Step 4b: Inserting into Formwork

Insert the anchor channel into the formwork.

Step 4c: Securing in Formwork

Secure the anchor channel within the formwork using wire ties.

Step 4d: Placement on Surface

Position the anchor channel on the prepared surface, potentially with additional reinforcement.

Step 5: Positioning Multiple Channels

Position multiple anchor channels and fix them with anchors. Use a tool for adjustment ?.

Step 6: Marking the Surface

Mark the concrete surface at the required position. Do not place directly on the surface without proper preparation ?.

Step 7: Installation into Concrete

Install the anchor channel into the concrete. Observe warnings regarding moisture or adverse weather conditions ⚠️. Ensure correct alignment ↑. Refer to label '7' for details.

Step 8: Inserting Profiles

Insert compatible profiles into the anchor channel. Ensure correct insertion ✔️. Avoid incorrect insertion ?.

Step 9: Final Securing/Adjustment

Secure or adjust the anchor channel using the appropriate tool.