LOGO

EMTEK Single-Point Lock Key in Knob/Lever Installation

EMTEK-Single-Point-Lock-Key-in-Knob-Lever-Installation-PRODACT-IMG

Regoupillage du cylindre

STEP 1

Small hole should face downEMTEK-Single-Point-Lock-Key-in-Knob-Lever-Installation-FIG-1

Rotate key counterclockwise 90º while pressing wire into hole.

STEP 2EMTEK-Single-Point-Lock-Key-in-Knob-Lever-Installation-FIG-2

SLIDE LEVER KNOB OFF STEM

STEP 3EMTEK-Single-Point-Lock-Key-in-Knob-Lever-Installation-FIG-3

After re-pinning cylinder, insert lever/knob onto stem

STEP 4EMTEK-Single-Point-Lock-Key-in-Knob-Lever-Installation-FIG-4

Installation Guide Single-Point Lock, Key in Knob/LeverEMTEK-Single-Point-Lock-Key-in-Knob-Lever-Installation-FIG-5

Lock AssemblyEMTEK-Single-Point-Lock-Key-in-Knob-Lever-Installation-FIG-6

PreparationEMTEK-Single-Point-Lock-Key-in-Knob-Lever-Installation-FIG-7

Install Strike PlateEMTEK-Single-Point-Lock-Key-in-Knob-Lever-Installation-FIG-8

Install Latch

Fasten Latch using two #8 x 3/4” Wood Screws (provided).EMTEK-Single-Point-Lock-Key-in-Knob-Lever-Installation-FIG-9

Remove Inside Trim Plate

Remove inside lever/knob by loosening set screw w/ hex wrench (provided).

STEP 1EMTEK-Single-Point-Lock-Key-in-Knob-Lever-Installation-FIG-10

Unthread nut counterclockwise to remove from Interior Plate before installing on door.

STEP EMTEK-Single-Point-Lock-Key-in-Knob-Lever-Installation-FIG-11

Install Outside Trim Plate

Fasten Outside Trim Plate using two #8-32 x 1½” Pan Head Machine Screws (provided).EMTEK-Single-Point-Lock-Key-in-Knob-Lever-Installation-FIG-12

Install Inside Trim Plate

Screw in flat head screw and threaded nut to secure Inside Trim Plate to door

STEP 1EMTEK-Single-Point-Lock-Key-in-Knob-Lever-Installation-FIG-13

Tighten set screw after placing lever/knob on stem.EMTEK-Single-Point-Lock-Key-in-Knob-Lever-Installation-FIG-14

Copyright © 2021, Emtek Products, Inc., an ASSA ABLOY Group company. All rights reserved. Reproduction in whole or in part without the express written permission of Emtek Products, Inc. is prohibited.

Documents / Resources

EMTEK Single-Point Lock Key in Knob/Lever [pdf] Installation Guide
Re-Pinning Cylinder, Re-Pinning, Cylinder, Single-Point Lock Key in Knob Lever, Single-Point Lock, Lock Key in Knob Lever, Lock Key in Knob, Lock Key in Lever, Lock Key

References

Leave a comment

Your email address will not be published. Required fields are marked *