THRV 22 DOUBLE TEMPERATURE CONTROLLER
APPLICATION
This double thermostat monitors the temperature in the switching cabinet. It was specially developed to control the combination of fan and heater. It is two independently switching thermostats with a high switching capacity in a compact housing.
FEATURES
- Temperature controller for fan and heater
- 1x NC contact at rising temperature to control the heater
- 1x NO contact at rising temperature for regulation of the fan
- High power capacity
- Adjustable temperature 0 – 60 °C
- Mounting on DIN rail
- 10 A switching capacity at 250 V AC
TECHNICAL DATA
| Type | THRV 22 |
| Part number | 15 THRV 022 |
| Perm. operating voltage | 12 V DC– 48 V DC 125 V AC – 250 V AC |
| Output switch contact | 1x NC; 1x NO |
| Sensor switching system | Bimetall intern |
| Switsching contact resistance | < 10 mOHM |
| Switching difference (hysteresis) | 7 K |
| Switching precision | ± 4 K |
| Switching capacity | max. 10 A (1,6 A*) @ 250 V AC max. 15 A (2,5 A*) @ 125 V AC |
| Switching power | 30 W @ 48 V DC |
| Control range | 0 °C … +60 °C |
| Protection class | 0 |
| Degree of protection | IP20 |
| Operating temperature | -25°C… +80°C |
| Storage temperature | -45°C… +80°C |
| Admissible degree of humidity | max. 95% r.h., non-condensing |
| Electrical connections | terminal 0,5 … 2,5 mm² |
| Housing material and colour | PA6, UL94 V0 self-extinguishing, light grey RAL 7035 |
| Service life | > 1000.000 switching cycles |
| Weight | 80 gr. |
| Way of installation | on 35 mm standard rail |
| Approval | CE |
Inductive load
DIMENSIONED DRAWING
CONNECTION DIAGRAM
FUNCTION
| Contact status | |
| SP | Set point (thermostat value set) |
| ON | Switching point (contact closing temperature) |
| ti | Negative tolerance of set point |
| TL | Positive tolerance of set point |
| H | Hysteresis |
| OFF | Switching point (contact opening temperature) |
ACCESSORIES
| Type | Description | Part number |
| HAL 51 | Installation set with 2 screws | 19 HAL 051 |
MOUNTING/INSTALLATION
The controller is mounted on a 35 mm DIN standard rail. For this purpose, the controller is hooked in with the upper hooks and then snapped onto the standard rail by pressing. To remove the controller from the standard rail, first pull it down and unhook it from the front.
The THRV 22 has internal sensors. In order to record the actual internal temperature of the control cabinet, it must not be directly exposed to cold or heat sources, unless it is the assembly to be protected. After mounting, the controller must be wired as shown in the wiring diagram.
After installation, therefore, the correct operating direction and proper functioning of the control must be checked. The switching point is set with a slotted screwdriver.
Mounting
- Hook up at the top
- Snap on below
Removal
- Pull downward
- Unhook inclined manner
ELMEKO GmbH + Co. KG Graf-Zeppelin-Str. 5 56479 Liebenscheid Germany
Tel. +49/2736/509748-0 info@elmeko.de www.elmeko.de
Documents / Resources
 |
ELMEKO THRV 22 Double-Thermostat [pdf] Owner's Manual THRV 22 Double-Thermostat, THRV 22, Double-Thermostat, Thermostat |